Használati útmutató Mitsubishi WL6700U

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Mitsubishi WL6700U (8 oldal) a Projektorok kategóriában. Ezt az útmutatót 25 ember találta hasznosnak.

/ 8 PDF

1

LCD Projector

WL6700U

Controlling the projector using a personal computer

This projector can be controlled by connecting a personal computer with RS-232C terminal.

PC-controllable functions:

• Turning the power ON or OFF

• Changing input signals

• Inputting commands by pressing the buttons on the control panel and remote control

• Menu setting

Connection

RS-232C cableSERIAL

D-SUB 9-pinD-SUB 9-pin

To RS-232C

terminal

Important:

• Connect the computer with the projector on a one-to-one basis.

• Make sure that your computer and projector are turned off before connection.

• Boot up the computer fi rst, and then plug the power cord of the projector.

(If you do not follow this instruction, the Com port may not function.)

• Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.

1. Interface

1.1 Pin assignment of SERIAL terminal (D-SUB 9-pin)

Pin No.NameI/O

1 OPEN

2RXD IN

3TXD OUT

4 OPEN

5 GND

6 OPEN

7 OPEN

8 OPEN

9 OPEN

1.2 Communications format

PROTOCOL RS-232C

BAUD RATE9600 [bps]

DATA LENGTH8 [bits]

PARITY BITNONE

STOP BIT1 [bit]

FLOW CONTROLNONE

This projector uses RXD, TXD and GND lines for RS-232C control.

For RS-232C cable, the reverse type cable should be used.

Termékspecifikációk