Használati útmutató Monogram ZXD30B

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Monogram ZXD30B (2 oldal) a melegítő fiók kategóriában. Ezt az útmutatót 37 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

BEFORE YOU BEGIN

Read these instructions completely and carefully.

• IMPORTANT– Save these instructions

for local inspector’s use. Observe all governing

codes and ordinances.

• Note to Installer– Be sure to leave these

instructions with the Consumer.

• Note to Consumer– Keep these instructions with

your Owner’s Manual for future reference.

Installation

Instructions

WARMING DRAWER CUSTOM

PANEL ACCESSORY KIT

ZXD27B

ZXD30B

TOOL AND MATERIALS REQUIRED

• Phillips screwdriver

• Drill and appropriate bits

(Brad point recommended for drilling through

wood panels)

• Custom panel

• Custom handle (optional)

• Adhesive recommended for metal to wood

• Adhesive recommended for plastic to wood

PARTS SUPPLIED

• Lamp Jewel

• Metal mounting panel

This kit contains a mounting panel to support a

trimless custom drawer front up to 3/4” thick. The

tubular handle can be reinstalled onto the custom

panel with longer screws (not provided). Or, the

original handle can be replaced with a custom

handle of your choice. (Handle is not supplied.)

Choose a custom handle to match or complement

cabinetry hardware.

IMPORTANT: The warming drawer should be

installed according to the installation instructions

packed with the product. The original drawer front

will be removed and replaced with a custom panel.

• Cut edges of the drawer panel will be seen and

must be finished for best appearance.

• The custom drawer front panel, both raised and

flat design, should be constructed in the same

manner as typical cabinet doors.

• Order the custom drawer panel from the cabinet

manufacturer. Be sure to provide the exact

dimensions so that the panel is constructed

accurately.

• Order the optional custom handle to complement

or match surrounding cabinetry handles.

PREPARE DRAWER FOR

PANEL INSTALLATION

•Open the drawer fully.

• Turn the warming drawer off.

STEP 1

For installation of 27and 30″″wide

warming drawer custom panel and

custom handle.

REMOVE ORIGINAL

DRAWER FRONT

• Remove the two screws on each side and the

one screw at the bottom of the drawer edge.

•Remove the two screws on the inside of the

drawer at the top. Retain all screws.

– Support the drawer front as you remove

screws to prevent the possibility of falling.

STEP 2

PREPARE CUSTOM PANEL

• The custom panel must be sized to fit the

dimensions shown for your model.

• Drill a 5/16” diameter hole through the

appearance side of the panel. This hole will

allow the indicator “ON” light to be visible

through the custom panel. The cut edges will

be covered by the overlap of the lamp jewel.

– A Brad point drill bit is recommended.

STEP 3

A

10-1/2"

1-13/16"

1-3/4"

Drill 5/16" Dia.

Through Custom

Panel For Lamp Jewel

A = 26-3/4” for 27” Wide Models

A = 30” for 30” Wide Models

Termékspecifikációk