Használati útmutató NAV-TV Tooki NTV-KIT010

NAV-TV nincs kategorizálva Tooki NTV-KIT010

Olvassa el alább 📖 a magyar nyelvű használati útmutatót NAV-TV Tooki NTV-KIT010 (7 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/7
What s in the box!
Fig. 1 - Package Contents
1. Tooki module.
2. Plug n Play power harness.! !
3. MOST fiber optic cable with connector.
4. Microphone.
5. Fiber optic coupler.
NOTE: Due to differences in
manufacturing, some items may not
appear exactly as pictured.
1 2
3 4
5
Please inspect the contents of your package to make sure all parts are included, there are no loose wires in
the harness and the fiber optic cable isn t kinked, bent or otherwise deformed.(2) (3) !
NOTES:
1) To ensure the most reliable operation, Nav-TV recommends professional installation of our
products.
2) Fiber optic cable is much more fragile and sensitive than normal wire therefore:(3)
a) Make sure your hands are clean when working with the fiber.
b) Do not bend or coil the fiber excessively.
c) Do not scrape or attempt to strip the orange insulation of the fiber.
d) Do not use zip ties or wire ties on fiber cable; if you need to keep the excess fiber (loosely)
coiled, use tape only.
Tooki Install 2/22/2008
Rev 1
3950 120th NW Ave., Coral Springs, FL 33065
Tel. 561-955-9770 Fax. 561-955-9760
www.nav-tv.com info@nav-tv.com
Tooki Porsche
Bluetooth phone integration for Porsche PCM
Certain features are intended for passenger and off-road use only. User must obey all State and Federal regulations
Installation Instructions
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase.
This product is intended for off-road use and passenger entertainment only.
3) The fiber optic coupler is not required for the installation. DO NOT discard it. If the Tooki unit(5)
needs to be removed from the vehicle, then the fiber optic bypass must be installed in the place of
the Tooki to maintain the continuity of the MOST fiber optic ring.
Close up of Tooki
Fig. 2 - Connections
1. Microphone jack.
2. MOST fiber optic connector, with cover.
3. Power connector.
1 2 3
The Nav-TV Tooki module is a very sophisticated piece of equipment. Though the installation is fairly
straightforward, please read the entire manual prior to starting.
BEFORE YOU START: Verify if the vehicle is equipped with the factory phone module. Press
the TEL button on the PCM; if an “Insert SIM card” or “No card” message appears, then the factory
phone module is installed. If that is the case, (a) the factory phone module must be disconnected and
(b) the location of the phone module (under the passenger seat) is an ideal location to install the
Tooki, as it has both the fiber optic connection and a power connection.
NOTE: Even if the Tooki will not be mounted in the factory phone location, the factory phone
module still needs to be disconnected and the coupler/bypass will need to be used.. (5)
Therefore, NAV-TV recommends that location for mounting the Tooki.
Tooki Install 2/22/2008
Rev 1
Tooki Porsche
Bluetooth phone integration for Porsche PCM
Certain features are intended for passenger and off-road use only. User must obey all State and Federal regulations
Installation Instructions
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase.
This product is intended for off-road use and passenger entertainment only.
(Replace factory phone module)
To install the Tooki in the location of the original phone module:
1) Remove plastic covers from front and rear ends of seat sliding rails.
2) Remove 4 inverted torx bolts (E12) that hold down the seat at each corner.
3) Remove the SRS and seat harness plug from the front bottom of the passenger seat.
IMPORTANT NOTE: Once the Harnesses have been unplugged from the seat, DO NOT
close, open, lock or unlock the doors, turn on the ignition, or turn on the radio! Doing so may
trigger negative diagnostics, such as the airbag light.
4) Remove the passenger seat.
5) Remove 2 10mm bolts holding metal plate located just under the front right and left sides of the
carpet.
6) Starting from the front (where the bolts were removed), lift the metal plate.
7) Remove 2 10mm bolts that attach the factory phone module to the underside of the metal plate.
8) Remove 32-pin molex, MOST fiber optic and antenna connector from factory phone module.
9) The antenna connector is not necessary for this install (Cell phones have their own antennas.) Cut
off Red & Black wires and connector from Plug n Play power harness. Splice Red wire to (any)! !
Red/Green wire (constant 12v) on factory harness and Black to (any) Brown wire (ground) on
factory harness. Plug 8-pin molex (power) into Tooki. Remove gray fiber optic cover and plug
MOST fiber optic connector into Tooki. Plug microphone into Tooki.
10) Using velcro or double-sided tape, mount Tooki to floor. Run the microphone wire under the
carpet, along the side of the console and up to a suitable mounting location, such as: On top of
the steering column, in the driver s side A pillar or up by the rear view mirror.!
11) Carefully reassemble in reverse order, making sure not to activate any of the car s systems prior!
to reconnecting the harnesses from step .3
Tooki Install 2/22/2008
Rev 1
Tooki Porsche
Bluetooth phone integration for Porsche PCM
Certain features are intended for passenger and off-road use only. User must obey all State and Federal regulations
Installation Instructions
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase.
This product is intended for off-road use and passenger entertainment only.

Termékspecifikációk

Márka: NAV-TV
Kategória: nincs kategorizálva
Modell: Tooki NTV-KIT010

Szüksége van segítségre?

Ha segítségre van szüksége NAV-TV Tooki NTV-KIT010, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva NAV-TV

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva

MOZA

MOZA SR-P Útmutató

10 Április 2025
CaterChef

CaterChef 445001 Útmutató

9 Április 2025
IFM

IFM E40581 Útmutató

9 Április 2025
Livn

Livn Bolt Útmutató

9 Április 2025
Livn

Livn Beats Útmutató

9 Április 2025
IFM

IFM O3R252 Útmutató

9 Április 2025