Használati útmutató PAC C2R-VW2

Olvassa el alább 📖 a magyar nyelvű használati útmutatót PAC C2R-VW2 (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 18 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 4.8 csillagra

Pacic Accessory Corporation - Santa Ana, CA 92705

techsupport@pac-audio.com • Voice: 866-931-8021 • Fax: 714-835-3233 • www.pac-audio.com

03-16-10

Radio Replacement Interface

with Nav Outputs for select

Volkswagen CANbus Vehicles With

or Without Premium Audio Systems

C2R-VW2

1. Vehicles with or without a factory amplier: Connect the aftermarket radio’s

front and rear speaker wires to the 16 pin plug.

2. The accessory output wire is located on the 11 pin CAN INTERFACE harness

- connect this wire to the radio’s

accessory wire. The accessory wire

supplies +12v, 1 amp max when key is

in the accessory or ignition position (see

g. 1: If more current is needed).

3. 11 pin plug (to CAN INTERFACE):

White/Green - Steering Wheel Control (SWC) output.1.

Green - Connect this wire to the radio’s reverse input wire only.2.

Orange/White - Connect this wire to the radio’s Illumination input wire only.3.

Violet/White - Connect this wire to the radio’s VSS input wire only.4.

Red/White - Connect this wire to the radio’s parking brake input wire only. 5.

Please Note: The parking brake wire will output a neg (-) trigger at all times until the vehicle is moving at a

speed of approximately 3 mph or faster.

Note: Do not connect these wires to any circuit other than the aftermarket radio’s wire harness.

4. 11 pin plug (to SWC INTERFACE):

This is a quick connection to a radio specic SWC interface. No additional connections are necessary other than radio

control connections. Plug the radio specic SWC interface in to this connector and program the radio specic SWC

interface for version 2. Do not cut the loops. Refer to the SWC interface instruction manual for the radio specic control

function programming order.

Fig. 1

(using a SPDT relay)

85 86

30

87

87a

Ground

High Current 12v

(Fused)

12v Acc.

From

Interface

New High

Current Output

Diode 1N4005

or equivelant

23456

78

1011

Accessory Output

+12volts 1amp max.

9 1

23456

78

101

9 1

SWC Interface.

Program for Version 2

Radio Specific Steering

Wheel Control Interface

(Sold Separately)

Program SWC

Interface for Version 2.

CAN INTERFACE

Navigation outputs and

Amplifier Remote Input

See Chart for wire color

descriptions.

Radio Connections. See aside

Chart for color description.

YellowBattery +12v

Black Ground

BlueAmp Turn On Input

WhiteFront L + input

White / BlackFront L - input

GreyFront R + input

Grey / BlackFront R - input

GreenRear L + input

Green / BlackRear L - input

PurpleRear R + input

Purple / BlackRear R - input

Radio Connection Chart:

(Read the Installation Notes before making

connections to the provided radio harness)

CAN Interface Connection Chart:

RedAcc. Output (1 amp)

Red / WhiteP.B. Output (-)

Purple / WhiteVSS Output (Pulse)

Orange / WhiteIllum. Output (+)

GreenReverse Output (+)

White / GreenSWC Output

Page 1

Termékspecifikációk