Használati útmutató PAC RadioPRO 3 RP3-GM11

Olvassa el alább 📖 a magyar nyelvű használati útmutatót PAC RadioPRO 3 RP3-GM11 (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 14 ember találta hasznosnak.

/ 2 PDF

RP3-GM11

Radio Replacement Interface for General Motors Vehicles

Pacifi c Accessory Corporation® | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com

©2013 Pacifi c Accessory Corporation

www.pac-audio.com

Rev. 120513

Pifi ACti

3

3

3

Introduction & Features

Important Notes

Wiring Connection Chart

Illustration / Schematic

The RP3-GM11 interface allows the replacement of a factory radio in select General Motors vehicles with Class II radios. Using

this interface will retain factory features such as Warning Chimes and BOSE® amplifi er (Standard or Premium) when the original

radio is removed. The RP3-GM11 provides data bus driven outputs such as retained accessory power (RAP), vehicle speed

sensor (VSS), illumination, reverse trigger and parking brake. The RP3-GM11 also provides a secondary output for adding an

optional PAC Steering Wheel Control (SWC) retention interface (SWI-RC, SWI-PS, SWI-JACK, SWI-ECL2 or SWI-X). Rear Seat

Controls (RSC) if equipped will also be retained with the SWI interface.

1. When used in Non-BOSE® applications simply cut off the RCA connectors and connect the remaining wires to the aftermarket

radios high level speaker outputs.

2. For BOSE® systems, the recommended line level input is between 2-4 volts from the aftermarket radio.

3. RSC buttons that are identical to the SWC will mimic the SWC one for one

4. To prevent over driven audio when installing the interface into a vehicle with a BOSE® system, and the aftermarket radio does

not have low level outputs, then an LOC (part # SOEM-4 or LP3-4) is recommended to match the input voltage or you can create

an audio attenuation circuit (see diagram 2 below for audio attenuation wiring).

5. Use the 4 position selector switch located on the side of the interface to select the best chime output volume for your specifi c

installation .

Red / WhiteParking Brake

Output (-)*

Purple / WhiteVehicle Speed

Output*

Blue / WhiteAmp Turn On Input

RedAccessory Output

(10 amp)

Orange / WhiteIllumination Output

(+)*

GreenReverse Output (+)*

Interface Connector

YellowBattery +12v

Black Ground

BlueAntenna On Input

WhiteFront L + input

White / BlackFront L - input

GreyFront R + input

Grey / BlackFront R - input

GreenRear L + input

Green / BlackRear L - input

PurpleRear R + input

Purple / BlackRear R - input

Vehicle Connector

Audio Attenuation Circuit for RP3-GM11

One channel shown

*Not all radios will have these

connections. Please insulate

these wires when not used.

Diagram 1

Chime Volume Adjustment

Cut for Non-Bose systems

Aftermarket Radio

Connections

To Vehicle

Connector

Connect to SWC

Interface. Program

for Version 2.

To optional SWC interface

Acc On

LED

Termékspecifikációk