Használati útmutató PAC RP5-GM51

Olvassa el alább 📖 a magyar nyelvű használati útmutatót PAC RP5-GM51 (5 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 22 ember találta hasznosnak.

RP5-GM51

Radio Replacement & Steering Wheel Control Interface

with OnStar Retention for General Motors Vehicles

Pacic Accessory Corporation

® | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com

©2014 Pacic Accessory Corporation

www.pac-audio.com

C

Page 1

Rev. 090914

SWC Connection

See above chart for

different radio type

connections

Introduction & Features

Important Notes

Wiring Connection Chart

Illustration / Schematic

The RP5-GM51 interface allows the replacement of a factory radio in select General Motors vehicles with 29-bit LAN v2 20 and 16 pin

connector radios. Using this interface will retain factory features such as OnStar, vehicle settings, steering wheel controls (SWC),

front and rear park assist and warning chimes when the original radio is removed. The RP5-GM51 also provides data bus driven

outputs such as retained accessory power (RAP), vehicle speed sensor (VSS), illumination, reverse trigger and parking brake.

1. Please make your vehicle settings selections before removing the factory radio for optimal installation time. Once the radio has been removed,

the vehicle settings which are normally selected through the factory radio can be accessed and changed by downloading and installing the

PAC Vehicle Settings program from http://www.pac-audio.com/rmware/RP/index.html.

2. The Voice button can be set to activate the factory OnStar function when pressed for longer than 1.5 seconds or given the ability to control

the aftermarket radio. This option can be found in the PAC Vehicle Settings program mentioned above in note one. The default setting for

these buttons is to control the factory OnStar. If these buttons are set to control the aftermarket radio, OnStar can still be accessed by using

the mirror controls.

3. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the interface into the

vehicle (see page 2 for setting chart).

4. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless you wish to

re-assign the SWC functions, utilize the buttons that have no initial programming or utilize short press long press dual command functionality

The SWC can always be restored to default settings by pressing and releasing the program button on the side of the interface once and

waiting 7 seconds for the LED to ash 4 times.

5. The LED will ash whenever a SWC button is pressed.

SWC Connector

Blu/Yel Kenwood or Newer

JVC

3.5mm Jack

Alpine, JVC,

Clarion, Pioneer,

Sony, Boyo, Dual,

Lightning Audio,

Visteon or Advent

WiringSWC Connection

Aftermarket

Radio

Connections

Vehicle

Connections

Red / WhiteParking Brake

Output (-)

Purple / WhiteVehicle Speed Out-

put

Blue / WhiteNot Used

Blue Not Used

Orange / WhiteIllumination Output

(+)

Green Reverse Output (+)

Brown LoopMute Loop

(See installation note 4.)

Aftermarket Radio Connections

YellowBattery +12v

Black Ground

Red Accessory Output

White Front L + input

White / BlackFront L - input

GreyFront R + input

Grey / BlackFront R - input

Green Rear L + input

Green / BlackRear L - input

PurpleRear R + input

Purple / BlackRear R - input

Vehicle Side Connections

Green/BlackSWC Input

Termékspecifikációk