Használati útmutató Panduit CT-160

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Panduit CT-160 (9 oldal) a Energiemeters kategóriában. Ezt az útmutatót 25 ember találta hasznosnak és 7 felhasználó értékelte átlagosan 4.3 csillagra

CAUTION:

Verify power is “OFF” before working on wiring with this tool.

The plastic grips are for the user’s comfort,

and are not intended to insulate against electrical shock

while working on live electrical circuits.

CT-160

CRIMPING TOOL

OPERATION INSTRUCTIONS

10-32

.80

1.0

1.3

1.6

2.0

2

.6

MM

CUTCOPPERONL

Y

22

20

18

16

14

1

2

10

AWG

8-32

6

-32

M5

M4

M3

.5

INSULA

TION

AUTO

7

-8

MM

INS

INS

NO

N

INS

NO

NINS

12

-1 0

22

-1 4

12

-1 0

22

-1 4

CLO ESHERE

I

N

S

E

R

T

S

C

R

E

W

S

T

H

I

S

S

I

D

E

CT-160

NON-INSULATED BUTT SPLICE

INSTRUCTIONS

1.Insert stripped wire into end of the butt

splice to internal wire stop. (See product

packaging for proper strip lengths.)

2.Locate butt splice in proper non-

insulated crimp pocket.

3.Position crimp pocket on the center of

the metal barrel half with wire inserted.

4.Squeeze handles firmly.

5.Repeat for other end of butt splice.

Page: 1 of 2

PA24427A01

REV.: 02 5-2014

OPERATION INSTRUCTIONS

© Panduit Corp. 2014

CT-160

For Technical Support:

1-888-506-5400, ext. 83255

E-mail:

techsupport@panduit.com

See product packaging or contact Customer Service for

UL/CSA approved tooling/product combinations.

INSULATED BUTT SPLICE

INSTRUCTIONS

1.Insert stripped wire into end of the butt

splice to internal wire stop. (See product

packaging for proper strip lengths.)

2.Locate butt splice in proper insulated

crimp pocket.

3.Position crimp pocket on the center of

the metal barrel half with wire inserted.

4.Squeeze handles firmly.

5.Close insulation if desired.

6.Repeat for other end of butt splice.

WIRE STRIPPERfor removing plastic or

rubber wire insulation. Strip length should

allow a minimum of 1/32” of conductor to

extend beyond terminal barrel.

WIRE CUTTER for No. 10 AWG and

smaller copper wire.

CUTTERS for machine screws of sizes

shown. Open handles, thread screw in this

side. Close handles to cut screw.

CRIMPING POCKETSfor Pan-Term non-

insulated and insulated terminals,

disconnects, splices and wire joints on No.

22 to 10 AWG stranded wire. See product

packaging for proper crimping pockets.

This tool is made of hardened steel and is

protected with a light coat of oil.

NON-INSULATED AND INSULATED

PARALLEL SPLICE INSTRUCTIONS

1.Insert stripped wire into each end of the

parallel splice. (See product packaging

for proper strip lengths.)

2.Locate parallel splice in proper crimp

pocket.

3.Position crimp pocket on the center of

the metal barrel.

4.Squeeze handles firmly.

CRIMP POCKET

CRIMP POCKET

CRIMP POCKET

CRIMP POCKET

NON-INSULATED

INSULATED

www.panduit.com

Termékspecifikációk