Használati útmutató Panduit RT2HT

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Panduit RT2HT (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 11 ember találta hasznosnak és 7 felhasználó értékelte átlagosan 4.1 csillagra

Website: www.panduit.com

E-mail: techsupport@panduit.com

For Technical Support:

888-506-5400, ext. 83255

RT2HT

MLT TENSIONING TOOL

© Panduit Corp. 2012

INTRODUCTION

The RT2HT Tool installs PanduitPan-Steel coated and

uncoated MLTEH (Extra Heavy Cross Section), MLTEH15

(Extra Heavy Cross Section .015” Thick Body), and

MLTSH (Super Heavy Cross Section .015” and .025”

Thick Body) stainless steel ties.

Note: This tool is not intended for other uses such as

cutting or tensioning other types of fastening

devices.

TOOL FEATURES

A.Rear Handle

B.*Tension Pawl Release - Knob pointing towards the front

of tool for pawl engagement and to rear of tool for

disengagement.

C.*Anti-Backup Pawl Release - Lever up against tool for

pawl engagement and pulled down to disengage pawl.

D.*Detent Lock Pins - For controlled tension, pull both pins

forward; for manual tension, push both pins backward.

E.Cutter Handle - Cuts tie when tie is tensioned properly.

F.Cutter Blade

G.Tensioning Mandrel

H.*Tension Indicator Window - Located on the back of front

handle.

I.*Adjustment Knob - Adjust tension of tie application and

lock to desired tension with tension locking screw.

J.Tension Locking Screw

K.Front Handle - With ratchet controlled tensioning.

* See Page 2 for Feature Detail

E

D

C

A

B

FIGURE 1

TOOL OPERATION

1.Loop tie around bundle, thread tie into nose of tool and

through slot of tensioning mandrel.

2.Pull front handle to tension tie. Under controlled tension,

the front handle will break free when pre-determined

tension is attained.

3.Push cutter lever downward to cut tie.

4.Remove cut-off portion of tie from tool.

PA25757A01

Rev: 01 12-2012

I

J

H

G

F

FIGURE 2

K

RT2HT: PA25757A01_01Page: 1 of 212-2012

Termékspecifikációk