Használati útmutató Panduit WMPFSE-E

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Panduit WMPFSE-E (80 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 11 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.0 csillagra

© Panduit Corp. 2003

For Worldwide Subsidiaries

and Sales Offices visit

Web Site: www.panduit.com

INSTRUCTIONS CM282C

Technical Support Phone: 866-405-6654

Fax: 708-444-6993

E-mail: ncginfo@panduit.com

Page 1 of 1

Cable Capacity

Part NumberUTP Cable

.187 dia.

SeTP Cable

.250 dia.Fiber

3mm dia.

Method 1

Method 1

Method 1

Method 2

Method 2

Method 2

WMP1E

WMPF1E

WMPFSE

WMPH2E

WMPHF2E

WMPLFSE

WMPLSE

WMPSE

9672 312

72 48 192

4832 144

24 16 72

32

16

24

12

96

48

Flange

The PatchLink cable manager isrecommended for use with Panduit 24or 48 port patch panelsmounted above and below the manager.

When routing the cables for the patch panels, either of the following two methods are recommended to help maintain cable bend radius.

METHOD 1:For each row of 24 ports, place two cables in each slot on the manager.

Route half the cables through each of the wire retainers on the ends of the manager.

METHOD 2: If the cables are coming from oneside ofthe rack, place 2 cables in each of the slots on the manager.

Wire

Retainer

Wire

Retainer

METHOD 1

METHOD 2

19” Rack

Screws

Finger

Finger

WMP1E (shown)

Cover

Part Numbers: WMP1E, WMPF1E,WMPFSE, WMPH2E, WMPHF2E, WMPLFSE,

WMPLSE, WMPSE

WMP1E

WMPF1E

WMPFSE

WMPH2E

WMPHF2E

WMPLFSE

WMPLSE

WMPSE

The hinged cover opens from the top or the

bottom. Pull flange to open and close cover.

P LATCH INK

Cable Management Horizontal Panels

Install the managers to the rack with the #12-24x.5 or M6 screws provided. Built-in

screw retention in mounting holes secures screws in manager during installation.

Install the covers to the manager by positioning coverflat against the front of the

managerfingers, then push to snap in place.

Note: The recommended assembly torque shall be 9+/-1 in-lb for #12-24 screws,

1+/-0.1 N-m for M6 screws.

NOTE: Whenusingfront andbackWMPH’sto managecablesonthe rearofthe rack,place2 cablesin eachof the12 slotsin therear of

the manager, for each row of 24 ports.

Termékspecifikációk