Használati útmutató Pyle PDC21
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Pyle PDC21 (6 oldal) a Vevő kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 1.5 felhasználó értékelte átlagosan 4.0 csillagra
Oldal 1/6
1/4'' Instrument To Balanced
& Unbalanced (1/4''/XLR) Direct Box
PDC21
www PyleUSA com
2
Front and Rear Panel Layout
1. INPUT: 1/4" input connector.
2. PARA OUT: It’s parallel output 1/4" jack for passing the input signal through to a
stage amplifier or monitor system.
3. ATT Switch: input attenuation, switchable(0dB,-20dB,-40dB)
4. BALANCED OUTPUT: Male XLR connector.
5. When engaged, the ground from the PDC21 chassis detaches from the GROUND:
XLR jack.
PDC21 Operation
A direct box, or DI box, provides the facility for the direct insertion of an audio signal
into a mixer or recorder. The oers a variety of DI solutions for live sound and PDC21
recording applications. You can connect all kinds of audio signals like guitars,
keyboards, outboard signal processors and even the high-powered speaker output
from an amplifier. The enables you to tap o the signal from a guitar or bass PDC21
guitar and pass the signal from the PARA OUTPUT to the on stage amplifier without
aecting the original sound. This can eliminate the need for mixing the guitar
amplifier, which in many cases is preferable, especially with bass guitar. The is PDC21
also very useful for connecting unbalanced signals from sources like signals DJ and
sub-mixers, eects processors and keyboards to a main PA or recording mixer.
1 2 3
5 4
Balanced Output
(opposite panel)
Input
Amp Speaker
Output
Amplier Amp Speaker
Input
PA Mixer
Link Output
SIGNAL FLOW
SIGNAL FLOW
www PyleUSA com
3
The balanced output provides a clean signal at a low level so long runs of PDC21
cable are possible. Another benefit from a balanced connection is common mode
rejection, which provides cancellation of the bad sounds (hums and buzzes) while
leaving the original signal pure.
Direct insertion of an Instrument into a PAsystem
One of the most common applications for using a DI box is getting the signal of
a bass guitar into the PA system. Simply put, the low frequencies produced by bass
are dicult to mic, so use of a DI box is almost always preferable. In addition, the
signal going to PA system can be tweaked by the FOH (front of house) engineer,
without aecting the sound the musician dials up on stage. You can use PDC21 to
plug a guitar directly into the PA system as well. Especially acoustic guitars with
pickups and when using electronic guitar processors and modelers. Follow the
diagram and steps below to connect a guitar to a PA mixer.
• Connect the output of the guitar or bass to the INPUTPDC21
• Connect 's PDC21 PARA OUT to the input of the guitar or bass amplifier.
• Connect 's to the input of main PA mixer.PDC21 BALANCED OUTPUT
NOTE:
To avoid annoying pops and clicks be sure to mute (or turn down the volume control)
of your mixer’s output while connecting the PDC21.
Termékspecifikációk
| Márka: | Pyle |
| Kategória: | Vevő |
| Modell: | PDC21 |
Szüksége van segítségre?
Ha segítségre van szüksége Pyle PDC21, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók Vevő Pyle
13 Január 2025
6 December 2024
6 December 2024
30 Szeptember 2024
22 Szeptember 2024
21 Szeptember 2024
19 Szeptember 2024
18 Szeptember 2024
16 Szeptember 2024
13 Szeptember 2024
Útmutatók Vevő
- Vevő Strong
- Vevő Phonic
- Vevő Audio-Technica
- Vevő Sunfire
- Vevő GoGen
- Vevő Nexa
- Vevő Terratec
- Vevő Advance
- Vevő AKAI
- Vevő Bugera
- Vevő Harman Kardon
- Vevő Vimar
- Vevő Bose
- Vevő Fostex
- Vevő Sonifex
Legújabb útmutatók Vevő
9 Április 2025
9 Április 2025
5 Április 2025
5 Április 2025
2 Április 2025
2 Április 2025
2 Április 2025
31 Március 2025
31 Március 2025
30 Március 2025