Használati útmutató Pyle PGTAMPL100

Pyle Vevő PGTAMPL100

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Pyle PGTAMPL100 (2 oldal) a Vevő kategóriában. Ezt az útmutatót 13 ember találta hasznosnak és 7 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/2
30 Watt Guitar Amplifier
8'' Speaker with Volume, Bass, Treble,
Gain and Digital Reverb Controls
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Before going any further, make sure that your amplier is compatible
with your mains electricity supply.
1. Ensure that the (power) switch is set to the position.MAINS OFF
2. Connect the supplied mains (power) lead into the mains electricity supply.
3. Ensure that the VOLUME controls are set to zero.
4. Plug your guitar into an jack socket.INPUT
5. Turn the front panel switch to the position.MAINS ON
6. Turn the VOLUME up to your preferred level and your amplier is ready to play.
Function
1-2. HIGH and LOW INPUT: Input for your guitar. Use a good quality guitar cable
(i.e. one that’s screened/shielded) to help prevent noise, interference and
unwanted feedback.
3. GAIN: This control sets the operating level of the pre-amp. Simply turn up the Gain
control until the required amount of distortion is achieved.
4. Select the drive channel or normal channel.SELECT:
5. Increasing the Treble will make your sounds brighter and more cutting, TREBLE:
turning it down will decrease your tones edge and make it sound softer as a result.
6. Adjusts the sound level of middle-frequency range.MIDDLE:
7. Adjusts the sound level of the low-frequency range.BASS:
8. This equalization controls reverb lengthLENGTH:
9. This equalization controls reverb depthDEPTH:
10. VOLUME: This is the overall level control for the normal channel.
www.PyleUSA.com
1 2 3 5
46 7 8 9 10 11 12 13

Termékspecifikációk

Márka: Pyle
Kategória: Vevő
Modell: PGTAMPL100

Szüksége van segítségre?

Ha segítségre van szüksége Pyle PGTAMPL100, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek