Használati útmutató RIDGID 378

Olvassa el alább 📖 a magyar nyelvű használati útmutatót RIDGID 378 (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 12 ember találta hasznosnak és 3 felhasználó értékelte átlagosan 4.3 csillagra

Ridge Tool Co., Elyria, Ohio, U.S.A.

9/08

Printed in U.S.A.999-998-365.10

Pre-Cut Tube To Correct

Length

1. Add all blueprint center to center dimen-

sions for the total tube length. Mark tube at

this total length.

(Figure 1)

2. Because most blueprints are dimensioned

as though all corners were square, less

tube is actually required than the total of

the blueprint dimensions. Therefore,

REDUCE the total length by the number of

bends, using the Gain Scales on the

Swinging Arm.

(See Figure 2)

3. Reduce the measured length of tube from

Step 1 by one graduation for each 90˚ bend

using the scale marked “90˚ Gain”. Reduce

Length of tube by one graduation for each

45˚ bend using the scale marked “45˚ Gain”.

(See Figure 2)

Mark tube and cut.

Figure 1

A + B + C + D = Total Length

A

B

D

C

45˚

90˚

90˚

Swinging Arm

Rollshaft

Roll

Drive Arm

Tube

2 - 90˚ Bends

Gain

Total Length

Latch

Form

Handle

Ratchet Handle

Figure 2

Instructions For Nos.358,368 and 378 Tube Benders

Termékspecifikációk