Használati útmutató Seco-Larm SM-226L-3Q

Seco-Larm nincs kategorizálva SM-226L-3Q

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Seco-Larm SM-226L-3Q (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 13 ember találta hasznosnak és 7 felhasználó értékelte átlagosan 4.4 csillagra

Letöltés PDF

Oldal 1/2

Features:

Installation:

Parts List:

SM-226LQ / SM-226L-3Q

Overhead Door Magnetic

Contacts

Manual

Please read manual before the installation.

1. Mount the contact on the floor near the

bottom of the door. Ensure that the

contact switch is in a safe location away

from equipment interference and near

where the magnet will be when the door is

closed.

2. Run the armored cable out of the way.

Run two wires from the alarm control

panel and connect to the two wires

extending from the cable armor.

3. Mount the magnet on the roll up door so

that it will trigger the contact when the

door is closed. Be sure that the gap

between the contact and magnet does not

exceed 2

" (70mm).

NOTE: Contact and magnet must be installed

on the protected side of the door.

 Operating voltage: 12~24 VDC

 2

" (70mm) Gap for overhead doors

 Adjustable to fit most door-channel widths

 24" (61cm) Armored wire leads

 Reed switch has deactivated rhodium on

gold under-plating

 SM 226LQ For closed-loop circuits

 SM-226L-3Q For open or closed-loop

circuits

 Mounting bracket included

 Limited lifetime warranty

Contact Switches

Manual

Magnet with bracket

SECO-LARM

U.S.A., Inc.

16842 Millikan Avenue, Irvine, CA 92606

Website: www.seco-larm.com

Phone: (949) 261-2999 | (800) 662-0800

Email: sales@seco-larm.com

Type: S

49J5

SM-226LQ only

Alarm

Control

Panel

Floor on protected side of door

PITSW1

MI_SM-226Lseries_190206_ML.docx

LIFETIME LIMITED WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product.

SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be

responsible for any costs or charges for removal, installation, or reinstallation. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse,

neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes

other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM’s option.

In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited

warranty is for products sold and installed in the United States and Canada. For all other countries the warranty is 1 (one) year.

NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also