Használati útmutató Simrad Sensor

Oldalak 4 Engels nincs kategorizálva

Olvassa el ingyen online a(z) Simrad Sensor használati útmutatóját, vagy töltse le PDF-ben. Az útmutatót 42 ember találta hasznosnak. Kérdése van a modellről? Tegyen fel kérdést

Sensor Setup Guide
Sensor Setup Guide
| 1
*988-11035-002*
This document describes the setup for the following sensors:
• Fluid Level Sensor – tank levels for fuel*, water, gray water, live well, oil, and black water
• Fuel Flow Sensor – flow rate measurements of fuel for gasoline powered boats
• Fuel Data Manager – fuel used data from fuel flow messages it receives from up to three
• Temperature Sensor – temperatures for water*, outside, inside, engine room, cabin, live well,
bait well, refrigeration, and heating system
• Thru-Hull Temperature Sensor - temperatures for water*, outside, inside, engine room, cabin,
live well, bait well, refrigeration, and heating system
• Speed Sensor – boat speed
• Pressure Sensor – pressure data: Engine Boost Pressure, Engine Oil Pressure, Engine Water
Pressure*, Transmission Oil Pressure and Pitot Speed
* Sensor is pre-configured to display this information.
¼Note: The sensor must be installed and connected to the NMEA 2000 network. For installation
and connection information, refer to the installation guide for the sensor.
After the sensor is connected, you can display sensor data. For more information, refer to your
display operating manual.
Sensor Setup
Use the Device Information dialog to set the device name, configure, view sensor data, and
for some sensors calibrate and set alarms.
Select the sensor in the Device List to display the sensor Device Information dialog. The
following example shows selecting the Fluid Level sensor from a Simrad NSS Evo2.

Értékelje ezt az útmutatót

Termékspecifikációk

Márka: Simrad
Kategória: nincs kategorizálva
Modell: Sensor

Szüksége van segítségre?

Ha segítségre van szüksége Simrad Sensor, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek