Használati útmutató Sonel MRU-120

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Sonel MRU-120 (2 oldal) a Mérőberendezések kategóriában. Ezt az útmutatót 14 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 4.7 csillagra

Oldal 1/2
Enabling auto-zeroing
Disabling auto-zeroing
Sonel MRU-120
Earth Resistance Meter QuickStart
v1.00 | 26.05.2020
Connect the meter to the measured wire.
Run the measurement using START button.
2P
In order to eliminate the inuence of the resistance of the test leads
over the result of the measurement, its compensation (auto-zeroing)
has to be done.
Press START.
Using button enable mode.F1 AUTOZERO
Short-circuit the test leads.
Press START.
Using button enable mode.F1 AUTOZERO
Separate the test leads.
It is sufcient to realize compensation once for the given test leads.
It is also remembered once the meter has been turned off, until the
next successful auto-reset procedure.
First steps
Turn on the meter
Select the method and connect
Congure
Obtain the result
Measurements
The meter is designed for measurements at interference voltages which do not exceed 24 V
for RE measurements and 3 V for RCONTmeasurements. The voltage is measured up to 100 V,
but above 40 V is indicated as dangerous. The meter must not be connected to voltages ex-
ceeding 100 V.
UN>24V!
The voltage on the mea-
surement points exceeds
24 V but is lower than
40 V. The measurement
is blocked.
NOISE!
The value of the interfering
signal is too high. The result
may be distorted by additional
uncertainty.
LIMIT!
The uncertainty of the
electrode resistance
>30%. Uncertainties
calculated on the basis of
the measured values.
UN>40V!
and a contin-
uous
sonic signal
The voltage on the
measurement points
exceeds 40 V. The mea-
surement is blocked.
R>19,99
RE>19,99kΩ
RS>19,9kΩ
RH>19,9kΩ
ρ>999kΩm
Measurement range
exceeded. I
L>max
Excessive interfering
current, the measurement
error may exceed the
basic error.
Wire continuity measurement

Értékelje ezt az útmutatót

4.7/5 (9 Vélemények)

Termékspecifikációk

Márka: Sonel
Kategória: Mérőberendezések
Modell: MRU-120

Szüksége van segítségre?

Ha segítségre van szüksége Sonel MRU-120, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Mérőberendezések Sonel

Sonel

Sonel PQM-700 Útmutató

28 December 2024
Sonel

Sonel PQM-750 Útmutató

10 December 2024
Sonel

Sonel MRU-12 Útmutató

10 December 2024
Sonel

Sonel KT-510 Útmutató

2 Szeptember 2024
Sonel

Sonel MZC-340-PV Útmutató

30 Augusztus 2024
Sonel

Sonel KT-120M Útmutató

26 Augusztus 2024
Sonel

Sonel UV-260 Útmutató

26 Augusztus 2024
Sonel

Sonel MMR-640 Útmutató

26 Augusztus 2024
Sonel

Sonel DIT-120 Útmutató

26 Augusztus 2024

Útmutatók Mérőberendezések

Legújabb útmutatók Mérőberendezések

Uni T

Uni-T UT220 Útmutató

3 Április 2025
Uni T

Uni-T UT681C Útmutató

3 Április 2025
Uni T

Uni-T UT216C Útmutató

3 Április 2025
Uni T

Uni-T UT611 Útmutató

3 Április 2025
Uni T

Uni-T UT210D Útmutató

3 Április 2025
Uni T

Uni-T UT210C Útmutató

3 Április 2025
Uni T

Uni-T UT210B Útmutató

3 Április 2025
Uni T

Uni-T UT682 Útmutató

3 Április 2025
Uni T

Uni-T UT275 Útmutató

3 Április 2025
Uni T

Uni-T UT08A Útmutató

3 Április 2025