Használati útmutató Sony XS-GTX122LT

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Sony XS-GTX122LT (1 oldal) a Szórakozás az autóban és a vízen kategóriában. Ezt az útmutatót 15 ember találta hasznosnak.

/ 1 PDF

Power amplifier



600 (23 5/8)71.3 (2 7/8)





ø 342 (13 1/2)

Dimensions Unit: mm (in)



Reference Point



Reference Plane



Reference Axis

Precaution

•This product is designed to be installed in the

cargo space of vehicle. Do not install this product

in a place where it could distract you or another

driver from the road.

•The subwoofer system should be securely

installed so as to avoid injury in the event of

sudden braking.

•If your car is parked in direct sunlight and there is a

considerable rise in temperature inside the car,

allow the unit to cool down before use.

•Do not use the unit on a weak battery as its

optimum performance depends on a good power

supply.

•For safety reasons, keep your car audio volume

moderate so that you can still hear sounds outside

your car.

•If no power is being supplied to the cassette player

or tuner, check the connections.

•Please note the following when installing the units;

otherwise malfunction and/or deterioration in

sound quality may result.

–Do not touch the diaphragms and/or speaker

cones by hand or with tools.

–Do not put your fingers through the holes of the

frame.

–Do not drop foreign objects in the units.

Specifications

Speaker 30 cm (12 in), cone type

woofer

Enclosure Bass reflex type

Short-term Maximum Power*

1 1,350 W*2

Rated power 300 W*

2

CTA 2031 RMS Power 350 W

Rated impedance 4 Ω

Output sound pressure level 88±2 dB (1 W, 1 m)*

2

Effective frequency range 35 – 800 Hz*

2

Mass Approx. 9.5 kg (20 lb 15 oz)

Supplied accessories Parts for installation

Design and specifications are subject to change without

notice.

*1“Short-term Maximum power” may also be referred to as “Peak

Power.”

*2 Testing Condition : IEC 60268-5 (2003-05)

Before installation

•Choose the installation location carefully so that the

unit will not interfere with normal driving.

•Use only the supplied mounting hardware for a safe

and secure installation.

•Avoid installing the unit where it would be subject

to high temperatures, such as from direct sunlight

or hot air from the heater, or where it would be

subject to dust, dirt, or excessive vibration.

•As you will need to drill some holes to install the

metal fitting, check the underside (under the car, or

in the trunk) of the mounting location carefully to

make sure there is no fuel line, fuel tank, or electric

wires, etc. before drilling the installation holes.

Mounting Parts list



× 4

× 2





ø 5

× 8





Location

Cargo spaceRear the back seat

Mark and drill the screw holes in the car floor panel to install

the metal fittings using the screws . 

Decide the mounting location.

2

1

Caution

Make sure that the unit does not wobble.

Caution

Choose a location under which no fuel line,

fuel tank, or electric wires are present,

because the metal fittings will be attached

with tapping screws.

Pass each fixing band through each metal fitting fixed to the car floor panel.  

Place the unit in the center of the fixed metal fittings, then pass the fixing bands and 

tighten them as shown in the figure to secure the unit.

* Note that the direction of the metal fittings is correct.

Unit: mm (in)

3

4

Connect the striped speaker cord to the negative terminal.

As there is no low-pass filter built-in to this unit, be sure to adjust beforehand the amplifier you

connect to (we recommend a cut-off frequency of 30 – 500 Hz).

5









344 (13

5

/

8

)

96 (3 7/8)

*

XS-GTX122LT

4-728-335- (1)12

©2017 Sony Corporation Printed in Vietnam

Box Subwoofer

Instructions GB

Termékspecifikációk