Használati útmutató StarTech.com CRJ45C6SOL50

Olvassa el alább 📖 a magyar nyelvű használati útmutatót StarTech.com CRJ45C6SOL50 (2 oldal) a Kábelek PC-hez és perifériákhoz kategóriában. Ezt az útmutatót 11 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 4.5 csillagra

Quick-Start Guide

To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.

Manual Revision: January 25, 2019 1:04 PM

Product Diagram (CRJ45C6SOL50)

ConnectorFunction

1Pins x 8

• Used to connect the eight wires within the

Ethernet cable to the .Modular Connector

Requirements

• Unshielded Twisted Pair Patch Cable (UTC) x 1

• Modular Connectors x 2

• Crimping Tool x 1

• Cable Tester x 1

• Wire Cutter x 1

Installation

Notes: Wire Cutter’s are very sharp and should be used with extreme care.

Wiring should be completed by a certied professional as per the local safety and

building code guidelines.

1. Carefully using a strip the jacket o of the 1.5” from the end Wire CutterUTC Cable,

of the cable exposing the four pairs of twisted wires.

2. Spread the four pairs of twisted wires apart.

Note: CAT5e cables have a pull sting that will need to be removed.

CAT6 Cables have a spine that will need to be removed.

3. Untwist the four pairs of wires, creating eight separate wires.

Cat 6 RJ45 Modular Plug for Solid Wire - 50 Pack

1

4. Arrange the eight wires using either the T568A or T568B pattern. See Wire

Orientation for more information.

5. Using the , cut the eight wires 0.5” from the end of the wires, leaving a Wire Cutters

clean straight cut at the end of the wires.

6. Carefully insert the wires in the. Ensure that each of the wires Modular Connector

passes through the guides that are inside of the .Modular Connector

7. Push the into the slot in the and squeeze down Modular ConnectorCrimping Tool

on the handle to secure the wires in the .Modular Connector

8. Repeat steps 1 - 7 on the other end of the .UTC Cable

9. Using the on both ends of the to test each of the pins in the Cable TesterUTC Cable

Modular Connector.

Wire Orientation

T568A Standard:

Note: Start from the left of theand work towards the right (Pin Modular Connector

1 - 8).

PinWire

Pin 1• White/Green

Pin 2• Green

Pin 3• White/Orange

Pin 4• Blue

Pin 5• White/Blue

Pin 6• Orange

Pin 7• White/Brown

Pin 8• Brown

Termékspecifikációk