Használati útmutató StarTech.com M2E1BRU31C

Olvassa el alább 📖 a magyar nyelvű használati útmutatót StarTech.com M2E1BRU31C (2 oldal) a külső merevlemez kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 4 felhasználó értékelte átlagosan 4.8 csillagra

Quick-Start Guide

To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.

Manual Revision: December 18, 2019 6:37 PM

Product Diagram (M2E1BRU31C)

Exterior

ComponentFunction

1Power LED

• Solid: Indicates that the Enclosure is receiving

power.

• Flashing: Indicates that the Drive activity.

2USB-C Port

• Used to connect the Enclosure to the Host

Computer.

Interior

ComponentFunction

3Drive-Bay Screws x 4

• Used to secure the Drive Bay Cover in the

Enclosure.

4Drive Connector• Used to connect the Drive to the Enclosure.

USB 3.2 Gen 2 Type C IP67 Rugged NVMe Enclosure

5

Adjustable Drive

Length Holes

• Used to accommodate dierent drive lengths.

6

Drive-Mount Screw/

Nut

• Used to secure the Drive to the Enclosure.

Requirements

For the latest requirements and full manual, please visit www.startech.com/

M2E1BRU31C

Installation

Warning! Drives should be handled carefully, especially when they’re transported. If

you’re not careful with your drives, you may lose data as a result.

Installing an 80 mm Drive

1. Using the Torx Screwdriver (included), remove the Drive-Cover Screws (x 4) from

the bottom of the Enclosure and remove the Cover Plate.

2. Place the Drive next to the Drive Tray and align the screw groove on the Drive with

the Adjustable Drive Length Holes on the Drive Tray.

3. Use the Torx Screwdriver and to remove the Drive-Mount Screw from the

Enclosure.

4. Gently slide the connector on the Drive (on a 30-degree angle) into the Drive

Connector on the Enclosure.

Note: The connector on your drive is keyed so that it only ts one way.

5. Lightly push the Drive down into position on the circuit board.

6. Insert the Drive-Mount Screw through the screw groove on the Drive and into the

Drive-Mount Screw Hole on the Enclosure.

7. Using the Torx Screwdriver tighten the Drive-Mount Screw, being careful not to

over-tighten.

8. Place the Cover Plate back onto the bottom on the Enclosure. Make sure that the

Cover Plate is properly aligned with the top of the Enculosure creating a tight seal

and that nothing is obstructing the Cover Plate, in order to provide a water and

dust resistance seal.

9. Insert the Drive-Cover Screws back into the four corner on the bottom of the

Enclosure.

6

4

5

3

1

2

Termékspecifikációk