Használati útmutató StarTech.com PATA2SATA3

Olvassa el alább 📖 a magyar nyelvű használati útmutatót StarTech.com PATA2SATA3 (2 oldal) a Kábelek PC-hez és perifériákhoz kategóriában. Ezt az útmutatót 13 ember találta hasznosnak és 3 felhasználó értékelte átlagosan 4.5 csillagra

Bi-Directional SATA/IDE Adapter Converter

PATA2SATA3

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l’utilisateur - fr.startech.com

ES:Guía del usuario - es.startech.com

IT: Guida per l’uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

Packaging Contents

• 1 x SATA/ IDE converter adapter

• 1 x SATA cable

• 1 x SP4 to dual LP4 power Y-adapter cable

• 1 x Instruction Manual

Installation

IDE controller to SATA hard drive

1. Set the DIP switches on the adapter to either Master or Slave mode (see

DIP Switch Settings diagram).

2. Plug the 40-pin female IDE connector on the adapter directly into the

male 40-pin IDE connector on your motherboard or IDE/EIDE controller

card.

3. Connect a 7-pin SATA cable from the black “To Drive” connector to the

connector on the SATA hard drive.

4. Connect the SATA power from the computer power supply to the SATA

hard drive.

5. Connect an SP4 oppy power connector from the computer power

supply to the SP4 connector on the adapter. If one is not available use

the included LP4 to SP4 adapter cable to connect one of the LP4 molex

connectors from the power supply.

Instruction Manual

7-pin SATA

(To Drive)

7-pin SATA

(To Computer)

40-pin IDE

connector

4-pin SP4 oppy

power connector

SATA controller to IDE hard drive

1. The DIP switches do not matter in this mode.

2. Plug the 40-pin female IDE connector on the adapter, directly into the

40-pin male connector on the IDE/EIDE hard drive.

3. Connect a 7-pin SATA cable from the orange “To Computer” connector to

the 7-pin SATA connector on the motherboard or SATA controller card.

4. Connect an LP4 molex power connector from the computer power

supply to the hard drive.

5. Connect an SP4 oppy power connector from the computer power

supply to the SP4 connector on the adapter. If an SP4 connector is not

available, use the included LP4 to SP4 adapter cable to connect on of the

LP4 molex connectors from the power supply.

*actual product may vary from photos

System Requirements

• 40-pin IDE/EIDE or 7-pin SATA enabled computer system

• 3.5” IDE/EIDE or SATA hard drive

Manual Revision: 01/27/2012

For the most up-to-date information, please visit: www.startech.com

Termékspecifikációk