Használati útmutató Tado Starter Kit - Wireless Smart Thermostat V3 plus Wireless Receiver and Wireless Temperature Sensor Thermostaat

Tado Termosztát Starter Kit - Wireless Smart Thermostat V3 plus Wireless Receiver and Wireless Temperature Sensor Thermostaat

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Tado Starter Kit - Wireless Smart Thermostat V3 plus Wireless Receiver and Wireless Temperature Sensor Thermostaat (8 oldal) a Termosztát kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 3.5 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF

Oldal 1/8

This manual is meant exclusively for professional installers. It includes generic instructions to install the Wireless

Receiver and the Wireless Temperature Sensor.

Manual for Professional

Installers

For the Starter Kit - Wireless Smart Thermostat V3+

English International

Manual version 3.2

DIY Installation

If you are not a professional installer, please download the tado˚ app. There you will find specific installation instructions.

A. Remove the battery

protection strip.

B. Press the button for

3 sec to start pairing.

C. Pairing may take up

to 2 min.

D. The static icon below

indicates successful pairing.

If pairing fails (E0), make sure the distance between the devices is approximately 3 meters. Pair again by pressing the

button for 3 sec.

2. Pair the Wireless Temp. Sensor

1. Install the Internet Bridge

A. Connect the Internet Bridge to the router.

If no free USB port is available on the router, use the

included 5V power adapter.

B. Press and hold the pairing button until the pairing LED

starts blinking.

min

sec

Solid on

Blinking

Power supply Connection with other

tado˚ devices

Device errors Heat request

When tado˚ is requesting heat, the Heat request symbol will either fade in and out or be solid ON. When OFF, tado°

is not requesting heat.

Unfold to check:

Step 4: Wire the Wireless Receiver

Step 5: Pair the Wireless Receiver

Step 6: Configuration

Extra information: Wireless Receiver Symbols

A. Mount the Wireless Temperature Sensor to the wall

using the included screws or the adhesive pads.

B. Mount the Wireless Receiver to the wall using the

included screws.

3. Mount tado˚ devices

Click

Don‘t plug in

to power until

the cover is on.

Termékspecifikációk

Márka:	Tado
Kategória:	Termosztát
Modell:	Starter Kit - Wireless Smart Thermostat V3 plus Wireless Receiver and Wireless Temperature Sensor Thermostaat

Szüksége van segítségre?

Ha segítségre van szüksége Tado Starter Kit - Wireless Smart Thermostat V3 plus Wireless Receiver and Wireless Temperature Sensor Thermostaat, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek

Az Ön neve*

Az Ön e-mail címe*

Írja ide kérdését