Használati útmutató Technoline WS 9116

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Technoline WS 9116 (2 oldal) a Software kategóriában. Ezt az útmutatót 9 ember találta hasznosnak és 8 felhasználó értékelte átlagosan 5.0 csillagra

INTRODUCTION WS 9116

FEATURES:

• Four digit time display

• 12-hour or 24-hour selectable time

• Indoor temperature (°C or °F)

• Outdoor temperature (°C or °F)

• Minimum and Maximum temperature

• Four level RF strength indicator

• Wall hanging or free standing

• Low battery indicator for receiver and transmitter

SET UP:

NOTE: This temperature station can receive one transmitter only.

• First, insert batteries into the transmitter, observing the correct polarity (see

marking inside battery compartment). Keep transmitter 5-10 feet from the

temperature station.

• Within 30 seconds of powering up the transmitter, insert batteries into the

Temperature Station, observing the correct polarity (see marking inside battery

compartment). Once the batteries are in place, all segments of the LCD will

light up briefly.

Following the indoor temperature will be displayed. If the indoor temperature is

not shown in the LCD after 60 seconds, remove the batteries and wait for at

least 60 seconds before reinserting them. Once the indoor data is displayed

you may proceed to the next step.

• After the batteries are inserted, the Temperature Station will start receiving

outdoor temp data from the transmitter. The outdoor temperature should then

be displayed on the Temperature station. If this does not happen after 2

minutes, remove the batteries from both units and start again from the

beginning.

• In order to ensure sufficient 433 MHz transmission, the outdoor transmitter

should be placed a distance of no more than 100 feet (30 meters) from the

Temperature Station and the transmitter.

TEMPERATURE SELECTION:

FAHRENHEIT/CELSIUS: Press the CF/SET button once to switch from

Celsius to Fahrenheit.

FOUR LEVEL RF INDICATOR: The temperature station will indicate strength

of signal reception from the outdoor transmitter by the number of bars on the

RF indicator icon.

4-bars: Shows after initial set up and stays when reception is at full strength.

3-bars: Indicates one reception failure from the outdoor transmitter.

2-bars: Indicates two reception failures from the outdoor transmitter.

1-bar: Indicates three reception failures from the outdoor transmitter.

Termékspecifikációk