Használati útmutató TP-Link Tapo S200D

TP-Link okos otthon Tapo S200D

Olvassa el alább 📖 a magyar nyelvű használati útmutatót TP-Link Tapo S200D (2 oldal) a okos otthon kategóriában. Ezt az útmutatót 11 ember találta hasznosnak és 6 felhasználó értékelte átlagosan 4.7 csillagra

Oldal 1/2
Product Introduction Wire Your Switch
Tapo smart dimmer switch turns on and
dims the lights automatically, saving you
eort and electricity bills.
Connect the wires to the smart dimmer
switch as shown below.
4
Disconnect the wires from the old switch.
Ground: Usually green or copper.
Neutral: Usually white and not connected to the dumb switch.
Line: Usually black and coming from the circuit breaker.
Load: Usually black. One end is connected to the light.
If you are unsure, consult a qualied electrician.
Turn o the circuit breaker. Then remove
the old wallplate of the wall switch and
label the wires.Ground and Neutral
1
2
Identify and Line Load wires.
3Line up the switch with the mounting
holes. Secure it with screws.
5Attach the wallplate and turn on the
circuit breaker. Then the wiring is
nished.
6
Flip the page over to complete setup.
1) Turn on the circuit breaker. Use a voltage detector
to identify the energized wire (Line wire).
2) and Turn othe circuit breaker. Label the Line Load
wires.
Take care to avoid electric shocks.
Load wireLine wire Power
Source
To Light

Termékspecifikációk

Márka: TP-Link
Kategória: okos otthon
Modell: Tapo S200D

Szüksége van segítségre?

Ha segítségre van szüksége TP-Link Tapo S200D, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek