Használati útmutató Vaddio RF Remote Commander

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Vaddio RF Remote Commander (3 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 25 ember találta hasznosnak és 5 felhasználó értékelte átlagosan 4.0 csillagra

Document Number 411-0058-40 Rev B – August 2022

User Guidefor the

Vaddio RF Remote Commander

August 2022

998-2180-000 (Worldwide)

The Vaddio RF Remote Commander provides basiccamera and conference functionality –

pan, tilt, zoom, presets, volume control, and muting, as applicable. You can also use the

remote to get the camera's IP address. This remote isa radio-frequency device, and is not

compatible with products that use IR (infrared)remotes.

Before you can use the RF remote, you will need to:

nInstall the batteries

nPair the remote with the camera

Installingthe Batteries

The remote uses two AAA batteries.

1.Remove the cover from the backof the remote. You may need to pressdown onthe

upper edge while sliding it off.

2.Install the batteries as shown in the diagram in the battery opening.

3.Slide and snap the cover back into place.

Pairing the Remote totheCamera

The camera does not recognize or respond to the remote until they are paired. Do thisafter the camera is

turned on and its statuslight is white.

To pair the remote using the camera’s IP button:

1.Press and hold the camera’s IP button until the status light blinks cyan.

2.While the camera’sstatus light blinkscyan, press the pairing button on the remote. The camera's

status light changes to steady white when the remote is paired. You may need to press the remote's

pairing button more than once.

3.If the status light changes color and keeps blinking, the pairing was not successful. Reboot the

camera and go backto step 1. Ifthe problem persists,contact Vaddio Technical Support.

To pair the remote using the camera’s administrative web interface:

1.On the Pairing page of the web interface, select Pair Remote.

2.When the camera's status light blinkscyan, pressand hold the pairing button on the remote until the

status light changes tosteady white.

Termékspecifikációk