Használati útmutató Varad IL2W

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Varad IL2W (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 28 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 4.4 csillagra

IL2W

IM-IL2Wv1

Thank you for purchasing the Varad IL2W, dual 1 watt LED

lighting system with driver. To ensure proper use please

carefully read this installation manual prior to installation.

Installation Guide

www.varad.com

1. IL2WC - Digital Controller

2. Two 1 watt LEDs

3. Mounting bracket

4. Power Harness

5. Self tapping screws, 4pcs.

6. flush mount screws, 2pcs.

7. Tie straps, 4 pcs.

Power HarnessLEDs

4

4

Digital Controller Description

Technical Specifications

Physical Specifications:

Digital controller:

Height - 0.75”

Width - 1.5”

Length - 2.25”

Current Draw - 250ma

LED:

Length: 3”, Width: 1.25”, Height: 0.55”

Wires:

12’ of cable

Electrical Specifications:

Digital controller:

12v - 24v input

LEDs:

Orange - ALINGAP, 350ma, 180 degree

Red - TS ALINGAP, 350ma, 180 degree

Blue/Green/White - INGAN 350ma, 180 degree

Parts List

Function

These 1 watt LEDs are designed to create accent

lighting for automotive interiors. Applications include,

speaker boxes, footwells, amplifier racks, doors and

much more...

Precautions

To prevent fire or shock hazard, do not expose the

digital controller to rain or moisture.

To avoid electrical shock, do not open the digital

controller. Refer servicing to a factory authorized

dealer. Do not attempt to disassemble the LED or

damage will occur.

Do not bend the wire away from the

bottom of the LED or water may leak

into the housing.

Required tools

· Wire Stripper

· Wire cutter

· Assorted drill dits

· Cordless drill

· Screwdriver

Installation of LEDs

Visually inspect for a location to mount the LED. The

light dispersion pattern will vary depending upon the

location of the LED. It is recommended that you power

up the LED and move it around to determine the

location that provides the best lighting. When you have

found a suitable location, begin to install by marking

each drilling point and pre-drill each hole with a 1/8” drill

bit. Mount the LED with supplied tapping screws. Once

again making an effort not to bend the wire away from

the bottom of the LED, so no damage should occur.

Termékspecifikációk