Használati útmutató VAX Rapide XL
Olvassa el alább 📖 a magyar nyelvű használati útmutatót VAX Rapide XL (7 oldal) a porszívó kategóriában. Ezt az útmutatót 8 ember találta hasznosnak és 4.5 felhasználó értékelte átlagosan 4.7 csillagra
Oldal 1/7
2
3
c
f
a
d
1
2
3
Putting your cleaner together
Remove your Rapide XL from the
carton with caution. The handle is
connected to the body by a cord.
Note: Do not tug or pull on the
cord.
Line up the handle to the upper
body of the machine and slide into
place.
Secure from the back with the two
smaller screws.
Phillips screwdriver required
Parts checklist
aHandle
bSolution trigger
cBrush on/off
dSoap on/off
ePower on/off
fClean water tank release
gClean water tank carry handle
hClean water tank
iCleaning solution soap tank
jDrain cap
kDual brushbars
lFront suction nozzle
mDirty water tank
nFloor/tools selector
oHose attachment cover
pDirty water tank handle
qDirty water tank nozzle tab
rDirty water tank latch
sDetachable tool storage
tHose
uWater supply connector
vUpholstery wash tool
wUpholstery tool trigger
xSolution/hose clip
yQuick cord release
zCarrying handle
aa Clean water tank cap
bb Hose storage clips
cc Power cord
dd Cord wrap
ee Handle release pedal
bb
aa
i
e
b
y
bb
x
z
g
h
j
k
l
m
n
o
p
q
r
c
d
e
s
t
u
v
w
cc
dd
ee
4
5
4
5 6
Putting your cleaner together
Feed the cord through the slots on
the back of the handle and push
into place.
Place a nut into the recess in the
back of the upper handle. While
holding the nut in place insert one
of the large screws through the
front of the upper handle and
tighten.
Repeat the process with the second
screw.
Remove the backing tape from the
screw cover and press into place.
1
2 1
Clean water tank
Note: Make sure the cleaning
solution tank is resting in place with
the solution tube pressed fully into
tube opening.
Line up the grooves of the clean
water tank with the support posts
inside the handle. Tilt the top of
clean water tank inward and push
until it locks into place.
To install the tool caddy, line up the
tabs of the tool caddy storage with
round tabs on the back of the han-
dle (above quick cord clip).
Tool storage
6
7
2
3
4
Tool storage
Slide the tool caddy downwards
until it is secured in place.
Note: The tool caddy can be
removed for storage on a wall.
Connect upholstery attachment to
end of hose by pressing until it
clicks into place.
Push upholstery attachment into
the left hose clip, wrap the hose
around the tool caddy starting on
the back groove of the storage
caddy.
Secure into place by pushing the
end of the hose into the hose clip
on the right. Press the solution/
hose clip onto the hose to secure
the solution tube in place (4a).
1
2 3
How to operate your cleaner
- setting up
Remove the clean water tank by
pressing the clean water tank
release and pulling the tank by the
handle. Put to one side to fill later.
While the clean water tank is
removed, loosen the solution tank
by gently pushing out the solution
plug from the plug opening.
Note: The solution tank can be
filled while it is attached to the
cleaner but you should use care
when refilling.
Remove the solution tank by pulling
up and out.
Note: The float in your Rapide XL is the transparent, pivoting moulded part in the dirty water tank, it will shut off the suction when the dirty
water tank is full. For best results use a smooth steady motion keeping the nozzle flat against the carpet. Tipping the cleaner and breaking the
seal of the nozzle against the carpet will cause the float to rise cutting off suction. Once the float is activated, empty the dirty water tank.
If the tank does not appear full turn off the power switch and wait for the float to settle. For best results use only VAX AAA Carpet Cleaner.
4a
Termékspecifikációk
| Márka: | VAX |
| Kategória: | porszívó |
| Modell: | Rapide XL |
Szüksége van segítségre?
Ha segítségre van szüksége VAX Rapide XL, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók porszívó VAX
7 Április 2025
1 Április 2025
1 Április 2025
1 Április 2025
30 Március 2025
19 Március 2025
11 Január 2025
26 December 2024
6 Szeptember 2024
6 Szeptember 2024
Útmutatók porszívó
- porszívó Malmbergs
- porszívó Techwood
- porszívó Manta
- porszívó Cotech
- porszívó Bush
- porszívó Medion
- porszívó Viomi
- porszívó Kenmore
- porszívó WOOZOO
- porszívó DeWalt
- porszívó Redmond
- porszívó Imarflex
- porszívó Trotec
- porszívó Neato Robotics
- porszívó Haeger
Legújabb útmutatók porszívó
10 Április 2025
10 Április 2025
10 Április 2025
10 Április 2025
10 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025