Használati útmutató Victrola VPT-800
Victrola
lemezjátszó
VPT-800
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Victrola VPT-800 (10 oldal) a lemezjátszó kategóriában. Ezt az útmutatót 8 ember találta hasznosnak és 4.5 felhasználó értékelte átlagosan 4.7 csillagra
Oldal 1/10

INSTRUCTION MAN UAL
VPT-80 0
A U T O M AT I C

Turntable
Dust cover
Platter with belt
Slipmat
45 RPM adapter
Power adapter / RCA cable
U N PAC K
Plug in power adapter.
Place 45 RPM adapter in corner compartment.
Remove foam support from back of tonearm.
Remove tonearm twist tie.
Remove tape and clear stylus cover.
Note: Gently pull stylus cover forward to remove.
P R E PA R E T U R N TA B L E
LOCATE TH E FOL LOWING ITEMS
Lower the platter on to the turntable.
Rotate the platter until the hole with the white ribbon is directly over the gold motor.
Pull both ends of the ribbon outward until the belt is extended past the motor.
Slowly release the belt until it is secured around the motor, then remove the ribbon.
Note: Ensure the belt is flat against the motor and not twisted.
Place the slipmat on the platter.
I N S TA L L P L AT T E R
PL ACE T URNTABLE ON A FLAT AND LE V EL SUR FACE
COMPLETE ALL STEPS BEFORE USE

C O N N E C T TO S P E A K E R S
Press and hold to power ON / OFF.
Single press to switch output modes:
RCA OUTPUT - LED: Flashes white, then solid white.
VINYLSTREAM™ (BLUETOOTH OUTPUT ) - LED: Flashes blue.
Note: When powering back ON, the turntable will return to the
last used output mode.
MULTI-FUNCTION BUTTON
Enter VINYLSTREAM (Bluetooth output) mode and turntable will
automatically enter pairing mode. LED: Flashes blue.
Make sure your Bluetooth device is in pairing mode.
Turntable will automatically pair to your Bluetooth device.
Once paired, LED will turn solid blue for one second, then turn solid white.
Note: Volume is controlled by Bluetooth device.
PAIR BLUETOOTH SPEAKER OR HEADPHONES
CONNECT RCA OUTPUT
Connect the turntable to external speakers or receiver using the included RCA cable.
RED PLUG - RED (RIGHT) JACK Insert into the
WHITE PLUG - WHITE (LEFT) JACK Insert into the
Set pre-amplier switch to the correct output:
LINE - If connecting to a line-level input.
PHONO - If connecting to an phono-level input.
For PHONO output, it is recommended to use a grounding wire (not included)
to connect the ground pin between the turntable and the external component.
Enter wired (RCA) output mode. LED: Flashes white, the solid white.
Termékspecifikációk
Márka: | Victrola |
Kategória: | lemezjátszó |
Modell: | VPT-800 |
Szüksége van segítségre?
Ha segítségre van szüksége Victrola VPT-800, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók lemezjátszó Victrola
31 December 2025
31 December 2025
31 December 2025
12 December 2024
18 Szeptember 2024
16 Szeptember 2024
13 Szeptember 2024
1 Szeptember 2024
25 Augusztus 2024
25 Augusztus 2024
Útmutatók lemezjátszó
- lemezjátszó Roksan
- lemezjátszó Sherwood
- lemezjátszó House Of Marley
- lemezjátszó Elta
- lemezjátszó Glorious
- lemezjátszó Brigmton
- lemezjátszó ION
- lemezjátszó Citronic
- lemezjátszó Lenoxx
- lemezjátszó Denver
- lemezjátszó Audio-Technica
- lemezjátszó Music Hall
- lemezjátszó Vintage Vinyl
- lemezjátszó Roadstar
- lemezjátszó Technaxx
Legújabb útmutatók lemezjátszó
29 Március 2025
14 Január 2025
14 Január 2025
12 Január 2025
11 Január 2025
11 Január 2025
11 Január 2025
11 Január 2025
6 Január 2025
6 Január 2025