Használati útmutató Viper AS5160

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Viper AS5160 (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/2
Use and maintenance
Operating guidelines AS5160 series
July 2018
Turn on the key and verify
there is enough battery power
to complete the work. Charge
batteries if required.
Install the squeegee using
the thumb nuts. Attach
squeegee hose.
Remove the red cover and fill
the tank. Add appropriate low
foaming detergent. Maximum
tank capacity 16 Gallons / 61
liter.
Check the level of water with
the red ball on the left side of
the machine.
Disc version: place the brush/pad holder under the scrub deck then use the pedal to lower the deck over the
brush. Press the OneTouchTM scrub button to enable scrubbing.
The vacuum will start. Push on one of the two switches ½ second to install the brush.
Boost version: attach a pad to the fixed pad holder, press the OneTouch TM scrub button and the deck will
lower auto matically.
Use the handle to lower or
raise the squeegee to the
floor. Adjust the squeegee
angle with the knob to adjust
suction performance if
needed.
Place the machine in working mode and
press any of the two red safety switches to
activate the machine.
Press the + or – solution buttons to
increase / decrease the water flow rate
or to turn solution off.
For wheel traction version: use the rabbit /
turtle knob to control the speed of the
machine.
BOOST version: Adjust scrub pressure when
needed.
For wheel traction version: pressing either
of the red safety switches and the black
reverse button together will put the
machine into reverse.
On disc version, the brush/pad holder can
be removed automatically by raising the
deck with the pedal and then press the click
off button.
Push
on the
button
Maintenance
Operating guidelines AS5160 series
July 2018
When scrubbing is complete,
turn off the key to perform
the following maintenance.
Daily: Empty the clean water
tank using the solution tank
drain knob under the
machine.
Daily: Empty the recovery
tank using the recovery
empty hose. Bend the soft part
before removing the cap to
control the flow.
Daily: Inspect and rinse the
float ball cage and inspect
and clean the lid gasket if
required.
Local Viper dealer:
Phone number:
SN:
Daily: Remove the squeegee, and clean.
Inspect the blades and flip them or replace
them if required.
Daily: to charge the battery, use the sup-
plied AC cord to the on board charger and
connect it to the machine and wall socket.
Weekly: Inspect the solution filter and
clean if required.
Daily: if the battery indicator shows red, put the machine on charge. Battery should
be on charge if empty, not in use or if not being used for coming 8-10 hours.
Daily: Leave the recovery tank lid open
after it’s been cleaned to avoid bad odor.

Termékspecifikációk

Márka: Viper
Kategória: nincs kategorizálva
Modell: AS5160

Szüksége van segítségre?

Ha segítségre van szüksége Viper AS5160, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva Viper

Viper

Viper AS510B Útmutató

21 Augusztus 2024
Viper

Viper AS4335C Útmutató

21 Augusztus 2024
Viper

Viper AS380/15 Útmutató

21 Augusztus 2024
Viper

Viper AS4325B Útmutató

21 Augusztus 2024
Viper

Viper AS5160T Útmutató

21 Augusztus 2024
Viper

Viper AS5160 Útmutató

21 Augusztus 2024
Viper

Viper AS7690T Útmutató

19 Augusztus 2024
Viper

Viper DR1500H Útmutató

18 Augusztus 2024
Viper

Viper AS7190TO Útmutató

18 Augusztus 2024
Viper

Viper AS530R Útmutató

18 Augusztus 2024

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva

MOZA

MOZA SR-P Útmutató

10 Április 2025
CaterChef

CaterChef 445001 Útmutató

9 Április 2025
IFM

IFM E40581 Útmutató

9 Április 2025
Livn

Livn Bolt Útmutató

9 Április 2025
Livn

Livn Beats Útmutató

9 Április 2025
IFM

IFM O3R252 Útmutató

9 Április 2025