Használati útmutató Vitek VT-1210A-D9B

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Vitek VT-1210A-D9B (23 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 12 ember találta hasznosnak és 6 felhasználó értékelte átlagosan 4.1 csillagra

DC 1210A 9CHV Power Supply Models --VT1210AD9B!

Installation instruction:

1. Install box at desired location in a cool place. The power

supply can be wall mounted. Make the hole position on the

wall using the back of the box as a template and drill four

mounting holes. Screw in the top two holes with the M4

screws and hang the power supply box - then affix the bottom

screws. Use drywall anchors if solid beams are unavailable.

2. Knock out (remove) the appropriate perforated knockouts for

running cables through.

3. When using approved optional backup battery, Connect Red

and Black wire from Battery input Terminal to battery terminal.

Red color is for Positive and Black color is for Negative.

4. Turn power switch to “OFF” position.

5. Connect each camera device to one "+U” & one “-U” power

output terminal. Be careful that the “+” & “-“ match at the

camera as well.

6.11 Plug the AC plug into local 0VAC power outlet. Turn power

switch to “ON” position. The green LED light should be on

showing power is being supplied to the camera.

7. Close the cover and secure it with provided screw.

Technical Specifications

Each channel is protected with a 1.6Amp,PTC resettable fuse.

Operation the temperature: -14 to +86 degrees F

Storage temperature: -14 to +140 degrees F

Notes:

1. When used in an extreme weather climate the power panel ,

may take up 30 seconds to boot up after initial connection to

power.

2. To avoid the risk of fire use only type STP-2 wire or heavier

gauge No.18AWG copper at minimum. Use wire suitable for

at least 194 degrees F.

!

! !

!

Termékspecifikációk