Használati útmutató Vitek VT-1230A-D18

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Vitek VT-1230A-D18 (1 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 8 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 4.2 csillagra

DC 1230AV 18CH Power Supply Models --VT1230AD18!

Installation instruction:

1. Install box at desired location in a cool place. The power

supply can be wall . Make the hole position on mounted

the wall using the back of the box as a template and drill

four holes. Screw in the top two holes with the mounting

M4 screws hang the power supply box - tand hen affix

the bottom screws. Use drywall anchors if solid beams

are unavailable.

2. Knock out (remove) the appropriate perforated knockouts

for running cables through.

3. Turn power switch to “OFF” posi. tion

4.U” Connect each camera device to one "+U” & one “-

power output terminal. Be careful that the “+” & “-“ match

at the camera as well.

5.11 Plug the AC plug into local 0VAC power outlet. Turn

power switch to “ON” position. The green LED light

should be on showing power is being supplied to the

camera.

6. Close the cover and secure it with provided screw.

Technical Specifications

Each channel is protected with a 1Amp,PTC resettable .85

fuse.

Operation emperature: - +86 degrees F the t14 to

Storage temperature: - degrees F 14 to +140

Notes:

1. When used in an extreme weather climate the power ,

panel may take up 30 seconds to boot up after initial

connection to power.

2.2 To avoid the risk of fire use only type STP-wire or

heavier No.18AWG cop . Use wire gauge per at minimum

suitable for at least 194 degrees F.

!

Termékspecifikációk