Használati útmutató Vitek VT-2415A-A18

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Vitek VT-2415A-A18 (1 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 3 felhasználó értékelte átlagosan 5.0 csillagra

Oldal 1/1
AC A) ) 24V (10A/15 (9CH CH/18 Power Supply Models - - - -VT 2410A A9 & VT 2415A A18!
Installation instruction:
1. Install box at desired location in a cool place. The power
supply can be wall . Make the hole position on mounted
the wall using the back of the box as a template and drill
four holes. Screw in the top two holes with the mounting
M4 screws hang the power supply box - tand hen affix
the bottom screws. Use drywall anchors if solid beams
are unavailable.
2. Knock out (remove) the appropriate forated knockouts per
for running cables through.
3. Turn power switch to “OFF” position.
4. U” Connect each camera device to one "+U” & one “-
power output terminal .
5. 11 Plug the AC plug into local 0VAC power outlet. Turn
power switch to “ON” position. The green LED light
should be on showing power is being supplied to the
camera.
6. Clos e the cover and secure it with provided screw.
Technical Specifications
Each channel is protected with a 1.1 ~1.6Amp, PTC
resettable fuse.
Operation the temperature: - +86 degrees F 14 to
Storage temperature: - +140 degrees F 14 to
Notes:
1. When used in an extreme weather climate the power ,
panel may take up 30 seconds to boot up after initial
connection to power.
2. 2 To avoid the risk of fire use only type STP- wire or
heavier 18AWG cooper . Use wire gauge No. at minimum
suitable for at least 194 degrees F.
!!!
!

Termékspecifikációk

Márka: Vitek
Kategória: nincs kategorizálva
Modell: VT-2415A-A18

Szüksége van segítségre?

Ha segítségre van szüksége Vitek VT-2415A-A18, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek