Használati útmutató Xaoc Lipsk
Xaoc
nincs kategorizálva
Lipsk
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Xaoc Lipsk (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 9 ember találta hasznosnak és 5 felhasználó értékelte átlagosan 4.2 csillagra
Oldal 1/8

binary
conversion
komputor
& bit inversion
commander
Models of 1989
operator’s manual rev. 1989/1.0

group of 8-bit signal processing devices offering
comprehensive digital signal manipulation, as well
as audio signal, control voltage, trigger, and gate
generation. Drezno is the input/output front-end
of the system, consisting of an analog–to–digital
-
analog signals and voltages based on their binary
bits of the digital signal representation.
-
be plugged into the bus board, paying close atten-
the negative 12V rail and should align with the dot,
–12V, or red stripe marks on both the unit and
reversed power connection, however reversing the
16-pin header may cause serious damage to oth-
er components of your system by short-circuiting the
Lipsk or more expansion modules to form an out-
-
-
-
should be fastened by mounting the supplied screws
-
vices, we strongly advise the user to read through the
entire manual before using the modules.
-
N-1
0
an 8-bit system, there are 256 possible values, from
value is in the top or bottom half of the range, and
system, the individual bits are represented as gate
-
coming analog voltage is converted into eight gates.
ADC input expects either audio or CV signals.
, represent-
ing each of the eight bits, 7 to 0
gain and offset sliders allow the user to
adapt the range of the signal fed to the A/D con-
expects only positive voltages, so for bipolar input
signals, set the slider to the upper position. offset
adc clock input allows
the user to override the internal clock by freezing
the output code at the rising edge of the input sig-
the adc clock allows the user to control the ADC
sampling rate. ADC output activity is indicated by
the corresponding set of eight yellow LEDs .
eight DAC gate inputs , representing each of the
eight bits numbered from 7 to 0dac output
produces a CV or audio signal based on the input
dac clock input expects gate/trigger
signals and is normalized to the ADC clock via the
ribbon cable connected to the expander sockets on
clock can be replaced by a clock produced by an ex-
pander module, and it can be overridden by any sig-
also features gain and offset sliders which
modules
explained

fig. 1
front panel
overview
Termékspecifikációk
Márka: | Xaoc |
Kategória: | nincs kategorizálva |
Modell: | Lipsk |
Szüksége van segítségre?
Ha segítségre van szüksége Xaoc Lipsk, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók nincs kategorizálva Xaoc
8 Január 2025
4 Szeptember 2024
21 Augusztus 2024
21 Augusztus 2024
21 Augusztus 2024
21 Augusztus 2024
21 Augusztus 2024
21 Augusztus 2024
21 Augusztus 2024
21 Augusztus 2024
Útmutatók nincs kategorizálva
- nincs kategorizálva Alienware
- nincs kategorizálva Hombli
- nincs kategorizálva Behringer
- nincs kategorizálva Teenage Engineering
- nincs kategorizálva RUBI
- nincs kategorizálva Moulinex
- nincs kategorizálva Könner & Söhnen
- nincs kategorizálva Magnus
- nincs kategorizálva SoundTube
- nincs kategorizálva Bolin Technology
- nincs kategorizálva Ondis24
- nincs kategorizálva Algo
- nincs kategorizálva Laserluchs
- nincs kategorizálva Neff
- nincs kategorizálva Klark Teknik
Legújabb útmutatók nincs kategorizálva
10 Április 2025
10 Április 2025
10 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025