Használati útmutató Atdec V-17T
                    Atdec
                    
                    nincs kategorizálva
                    
                    V-17T
                
                                
                
                
                                
                Olvassa el alább 📖 a magyar nyelvű használati útmutatót Atdec V-17T (4 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 10 ember találta hasznosnak és 5.5 felhasználó értékelte átlagosan 4.3 csillagra
                        Oldal 1/4
                    
                    
                    
DIY LED TAPE KIT 
User Manual 
DIY LED TAPE KIT - SINGLE COLOUR  
Introduction: 
Thank you for purchasing the Lyyt DIY LED Tape  .  Kit LED tape is ideal for use on the underside of a counter tops, shelves, cupboards, around 
window frames or in an alcove of a ceiling to name just a few examples. 
Before starting please ensure that you have read this instruction leaflet carefully.  
If you are unsure about any of the installation details, please have this installed by a competent installer.  
Blister Contents: 
1 x Reel of LED tape 
1 x UK power adap  tor
Possible Required tools: Scissors, Craft knife, Soldering iron and solder, 2 core DC wire and heat shrink tube. 
Step 1: Preparation 
Ensure that the surface you are attaching to is clear of dust and dirt. Clean thoroughly and leave to dry before fitting the tape. 
Unravel the tape and connect the power supply. Check that all the LEDs are functioning correctly and if there are any faults return to your retailer 
without delay. 
Step 2: Cutti  ng
WARNING: Disconnect from the power supply before attempting any cutting. 
Measure out each section and cut with sharp scissors at the marked 5cm intervals to achieve the perfect length. Do not discard any excess tape as 
it can be easily reconnected and used again (see FIG 2). 
Step 3: Fitting:  
Example 1: Simple straight run. 
Clear the area you wish to install the tape and remove the backing paper, exposing the adhesive tape. Push tape firmly onto the surface. It is 
recommended to work on 50cm sections at a time in order to ensure a professional finish. When you reach the end of your installation cut at the 
marked cutting point. 
Example 2: Requires cutting: 
The tape can be cut at highlighted 5cm intervals for a perfect fit.  
FIG 1: 
Termékspecifikációk
| Márka: | Atdec | 
| Kategória: | nincs kategorizálva | 
| Modell: | V-17T | 
Szüksége van segítségre?
Ha segítségre van szüksége Atdec V-17T, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók nincs kategorizálva Atdec
                        
                         29 December 2024
                        
                    
                                                            
                        
                         7 December 2024
                        
                    
                                                            
                        
                         7 December 2024
                        
                    
                                                            
                        
                         7 December 2024
                        
                    
                                                            
                        
                         29 Augusztus 2024
                        
                    
                                                            
                        
                         19 Augusztus 2024
                        
                    
                                                            
                        
                         19 Augusztus 2024
                        
                    
                                                            
                        
                         19 Augusztus 2024
                        
                    
                                                            
                        
                         19 Augusztus 2024
                        
                    
                                                            
                        
                         19 Augusztus 2024
                        
                    
                                                            Útmutatók nincs kategorizálva
- nincs kategorizálva BYD
- nincs kategorizálva Casaria
- nincs kategorizálva Steba
- nincs kategorizálva Celestron
- nincs kategorizálva Bimar
- nincs kategorizálva Zibro
- nincs kategorizálva Meec Tools
- nincs kategorizálva Vaillant
- nincs kategorizálva Siemens
- nincs kategorizálva FABER CASTELL
- nincs kategorizálva Crosley
- nincs kategorizálva Caso
- nincs kategorizálva Atlantic
- nincs kategorizálva Igloo
- nincs kategorizálva Veripart
Legújabb útmutatók nincs kategorizálva
                        
                         10 Április 2025
                        
                    
                                                            
                        
                         10 Április 2025
                        
                    
                                                            
                        
                         10 Április 2025
                        
                    
                                                            
                        
                         9 Április 2025
                        
                    
                                                            
                        
                         9 Április 2025
                        
                    
                                                            
                        
                         9 Április 2025
                        
                    
                                                            
                        
                         9 Április 2025
                        
                    
                                                            
                        
                         9 Április 2025
                        
                    
                                                            
                        
                         9 Április 2025
                        
                    
                                                            
                        
                         9 Április 2025