Használati útmutató AXESS AX-ADDCAM

Olvassa el alább 📖 a magyar nyelvű használati útmutatót AXESS AX-ADDCAM (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 17 ember találta hasznosnak.

/ 8 PDF

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

AX-ADDCAM

INSTALLATION INSTRUCTIONS

AxxessInterfaces.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 5/3/18 INSTAX-ADDCAM

INTERFACE FEATURES

TOOLS REQUIRED

INTERFACE COMPONENTS

TABLE OF CONTENTS

Introduction............................................................2

Connections to be made .......................................2

Configuring the AX-ADDCAM .............................3-5

Installing the AX-ADDCAM .....................................5

Programming the AX-ADDCAM .............................6

Connector pin-out (20-pin) ..................................7

AX-ADDCAM

• (4) Camera inputs

• Programmable 12V 5-amp switched output (configured through the Axxess Updater program)

• Reverse signal trigger generated via CAN bus communication of the vehicle

• Turn signal trigger generated via CAN bus communication of the vehicle

• (4) Programmable camera control wires (configured through the Axxess Updater program)

• Can also be manually controlled, and used along with an aftermarket radio

• VSS (Vehicle Speed Sense) input and output

• Micro “B” USB updatable

• Wire cutter • Crimp tool • Solder gun • Tape

• Connectors (example: butt-connectors, bell caps, etc.)

• AX-ADDCAM interface

• AX-ADDCAM harness

Termékspecifikációk