Használati útmutató AXESS AX-FT902

Olvassa el alább 📖 a magyar nyelvű használati útmutatót AXESS AX-FT902 (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 18 ember találta hasznosnak.

/ 8 PDF

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

AX-FT902

INSTALLATION INSTRUCTIONS

AxxessInterfaces.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 5/11/18 INSTAX-FT902

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS REQUIRED

• Wire cutter • Crimp tool • Solder gun • Tape

• Connectors (example: butt-connectors, bell

caps, etc.) • Zip ties

TABLE OF CONTENTS

Connections to be made ....................................2-3

Installing the AX-FT902 interface .........................3

Programming the ASWC-1 interface .................3-4

Screen operation ................................................4-6

Fiat 500X (with U-Connect)Data Interface with SWC & Factory Display Retention2015

• Provides accessory power

• Designed for non-amplified models

• Provides NAV outputs (parking brake, reverse, speed sense)

• Retains audio controls on the steering wheel

• Retains parking sensor chimes

• Retains balance and fade

• Retains most of the vehicle settings that was displayed on the

factory radio *

• Micro “B” USB updatable

• AX-FT902 interface

• ASWC-1 interface

• AX-FT902 harness

• ASWC-1 harness

• Female 3.5mm connector with stripped leads

• Chime Speaker

* Attention!

The aftermarket radios backup camera input will be used to display the vehicle settings. If the radio doesn’t have a backup camera

Input, then there will be no visualization of the vehicle settings. An externally mounted screen could be substituted in this situation.

Termékspecifikációk