Használati útmutató AXESS AXBUCH-T1

Olvassa el alább 📖 a magyar nyelvű használati útmutatót AXESS AXBUCH-T1 (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 23 ember találta hasznosnak.

/ 2 PDF

AXBUCH-T1AXBUCH-T1

INSTALLATION INSTRUCTIONSINSTALLATION INSTRUCTIONS

REV. 12/12/19REV. 12/12/19© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION

Integrate • AxxessInterfaces.comIntegrate • AxxessInterfaces.com

INTERFACE FEATURES

• Retains the factory back-up camera to an aftermarket radio

• Allows an aftermarket camera to be added to the factory screen*

* Display and navigation model radios only

INTERFACE COMPONENTS

• AXBUCH-T1 harness

Toyota Back-Up Camera Retain/Add-On 2012-2015

Scion

FRS 2013-2015

iQ 2014-2015

tC 2014-2015

xB 2014-2015

xD 2014-2014

Toyota

4-Runner

(w/o factory amp) 2012-2013

Avalon 2013-2014

Camry 2012-2013

Highlander 2013

Prius 2012-2015

Prius PHV 2012-2015

Prius V 2012-2014

Rav-4 (before build

date Nov. 2013) 2014

Rav-4 2013

Sequoia 2013

Tacoma (with NAV) 2012-2013

Venza 2013-2014

• Cutting tool • Tape • Crimping tool

• Connectors (example: butt connectors, bell caps, etc.)

APPLICATIONS

TOOLS REQUIRED

Connections to be made

The AXBUCH-T1 can be connected two different ways

To retain the factory back-up camera to an aftermarket radio:

• Connect the wire to chassis ground.Black

• Connect the Yellow wire to accessory power. *

• Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.

• Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle.

• Disregard the loose wire, it will not be used in this application.Green/Purple

* It is highly recommended to use the AXCSD-6V (sold separately) to provide the camera with

the proper voltage.

To allow an aftermarket camera to be added to the OEM screen:

• Connect the

Black

wire to the ground wire of the aftermarket camera.

• Connect the power wire of the aftermarket camera to accessory power.

• Tape off and disregard the

Yellow

wire, it will not be used in this application.

• Connect the female

Yellow

RCA jack to the aftermarket camera.

The following (2) steps are only required if a wire is

not present in the factory harness.

*Except Avalon 2013-2014 and Venza 2013-2014

• If a wire is not present in pin-2 of the 28-pin

connector of the factory radio, unplug the

connector, then insert the metal pin of the

loose wire into it. Connect the Green/Purple

harness back into the radio.

• Connect the other end of the loose Green/

Purple

wire to the reverse wire of the vehicle.

14 13 12 11 10 9 8 7 6 5 3 2 4 1

28 27 26 25 24 23 22 21 20 19 18 17 16 15

This is the wire view of the connector

in the vehicle

28 Pin Harness

Termékspecifikációk