Használati útmutató AXESS GMRC-03

Olvassa el alább 📖 a magyar nyelvű használati útmutatót AXESS GMRC-03 (4 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 14 ember találta hasznosnak és 7 felhasználó értékelte átlagosan 4.3 csillagra

METRA. The World’s best kits.™metraonline.com1-800-221-0932© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION

Installation Instructions for GMRC-03

REV. 11/14/2013 INSTGMRC-03

(continued on next page)

GMRC-03

GM Class II data bus interface

1996-2002

• Provides accessory (12-volt 10-amp)

• Retains R.A.P. (Retained Accessory Power), if equipped

• Used in non-amplified systems or when replacing amplified systems

• Retains all warning chimes through onboard speaker

KIT FEATURES

• GMRC-03 data interface

• 10-pin to 24-pin GM harness with stripped leads

INTERFACE COMPONENTS

• Cutting tool • Crimping tool • Tape

• Connectors (example: butt-connectors, bell caps, etc.)

TOOLS REQUIRED

CADILLAC

Catera 1997-2001

Deville 1996-1999

Eldorado 1996-2002

Seville 1996-1999

APPLICATIONS

CONNECTIONS TO BE MADE

From the 10-pin harness:

• Connect the Yellowwire to the to the radio’s 12-volt battery or memory wire.

• Connect the wire to the radio’s 12-volt accessory or switched wire.Red

• Connect the wire to the radio’s ground wire.Black

• When completed plug the 10-pin harness into the GMRC-03.

From the 32-pin harness:

• Connect the wire to the radio’s antenna turn-on wire. If no antenna turn-on Blue

wire is present, hook wire to the radio’s amplifier turn-on wire.Blue

• Connect the wire to the radio’s dimmer wire. If your radio does Orange/White

not have a dimmer wire, just tape off wire.

• Connect the wire to the radio’s left front positive speaker output.White

• Connect the wire to the radio’s left front negative speaker output.White/Black

• Connect the wire to the radio’s left rear positive speaker output.Green

• Connect the wire to the radio’s left rear negative speaker output.Green/Black

• Connect the wire to the radio’s right front positive speaker output.Gray

• Connect the wire to the radio’s right front negative Gray/Black

speaker output.

• Connect the wire to the radio’s right rear positive speaker output.Purple

• Connect the wire to the radio’s right rear negative Purple/Black

speaker output.

Termékspecifikációk