Használati útmutató CRUX SOOGM-15V

Olvassa el alább 📖 a magyar nyelvű használati útmutatót CRUX SOOGM-15V (4 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 13 ember találta hasznosnak.

Crux Interfacing Solutions • Chatsworth, CA 91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.113020

SOOGM-15V

Radio Replacement with OnStar, SWC Retention and

Video Switcher for GM Class II Vehicles

1 of 4

RADIO REPLACEMENT

SWC RETENTION

+

R

INTERFACING SOLUTIONS

PRODUCT FEATURES:

- Retains factory features in select GM Class II vehicles while funconing with an aermarket radio.

- Pre-programmed to retain factory Steering Wheel Controls.

- Retains OnStar and chime funcons.

- Adds Forced front and rear aermarket camera inputs while in moon using the SOURCE DOWN or AM/FM buon on the

steering wheel controls on select vehicles.

- Supports Bose, non-Bose and Y-91 audio systems.

- EIA color coded wiring for easy installaon.

1. The Front and Rear fading are not retained on Y-91 Bose System.

2. Chime includes: seat belt, check engine, key in ignion, low fuel, low oil and lights on.

NOTES:

SOOGM-15V ModuleSOOGM-15V HarnessVideo HarnessAntenna AdaptorSWC Cable

SETTING THE AFTERMARKET RADIO BRAND

With the key in the o posion, set the DIP switches to the corresponding aermarket radio seng:

RADIO BRAND: DIP#: 1 2 3 4

Atoto, Dual, Fahrenheit, Jensen,

Pioneer, Power Acoustik, Soundstream

Blaupunkt, Most o-brand Radio

Alpine

Clarion

Kenwood

JVC

Boss, Old Sony

New Sony

NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most o-brand radios,

check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.

SWC MODULE

DIP SWITCH

1 2 3 4

ON

OFF OFF ON ON

OFF OFF ON ON

OFF OFF ON ON

OFF OFF OFF OFF

OFF ON ON OFF

OFF ON ON ON

OFF ON OFF ON

OFF ON OFF OFF

OFF OFF ON OFF

PARTS INCLUDED:

DIP SWITCH SETTINGS:

3.5MM SWC CABLE

Plug in the SWC cable to the SWC module and the 3.5mm plug to the aermakert radio SWC port or use the Blue/Yellow wire

for JVC and Kenwood.

RED to SWC Key 1

WHITE to SWC Key 2

SHIELD to SWC Ground

For aermarket radios that have wires for SWC connecons, cut o the 3.5mm plug on the Crux SWC Cable (opon B) and

connect the SWC wires as follows:

Note that there are some radios that only have

SWC1 and SWC2, in this case “shield” does not

need to be connected.

Termékspecifikációk