Használati útmutató Elba ETC-E2700

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Elba ETC-E2700 (1 oldal) a Wekkerradio kategóriában. Ezt az útmutatót 19 ember találta hasznosnak és 4 felhasználó értékelte átlagosan 4.9 csillagra

1. Install the intake (A) on the wall.

2. Put the tape(C) around the screw threaded tube, cover the rosette (B) and screw into pipeline.

3. Connect water and check if the screw has been sealed tightly.

pipeline

●Before installation, please ensure that the following work

conditions are adhered to:

-Water temperature between 0C - 90C˚ ˚

-Water pressure between 0.05MPa – 1.0MPa. Pressure reducing

valve is necessary if pressure exceeds 1.2MPa

-Avoid major pressure dierences between hot and cold water ff

supply

●Flush pipes thoroughly before and after installation to ensure

water supply is free of any debris.

●Inspect tap fitting and debugged to its best. Do not attempt to

disassemble fitting on your own.

●Use thread sealant tape (PTFE) on any screw joining

connections and ensure all joints are securely tightened.

ETC-E2700

This . FIAMMA SDN. BHD. will not be held responsible for the use of superseded or voided specifications.

Fabricatoe must check for cut-out accuracy.

specification is subject to change without notice

StainlessSteelCold WaterTap

Termékspecifikációk