Használati útmutató GE UXADJB36PSS

Olvassa el alább 📖 a magyar nyelvű használati útmutatót GE UXADJB36PSS (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 21 ember találta hasznosnak és 7 felhasználó értékelte átlagosan 4.8 csillagra

UXADJB36PSS, UXADJB48PSS

30” to 36” Adjustable Backsplash

WARNING To prevent ignition of combustible

materials, the entire back wall above the range

must be protected by a backsplash constructed of

non-combustible material.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

■ IMPORTANT—Save these instructions

for local inspector’s use.

■ IMPORTANT—Observe all governing

codes and ordinances.

■ IMPORTANT—Remove all packing

material and literature from oven before connecting

gas and electrical supply to range.

■ Note to Installer —Be sure to leave these

instructions with the consumer.

■ Note to Consumer —Keep these instructions with

your Owner’s Manual for future reference.

■ This backsplash adjusts to fit the space between the

top of the range and the bottom of the hood, from

30” Min. to 36” Max. height.

■ Maximum shelf load-bearing weight is 40 lbs.

Installation

Instructions

TOOLS AND MATERIALS REQUIRED

■Glovestoprotectagainstsharpedges

■T-15and#2Phillipsscrewdrivers

■Drillwith3/32”and9/64”bits

■Safetyglasses

■Level

■Pencil

This Kit Includes

■Topwallsupport

■Bottomwallsupport

■Topcoverwithshelf

■Bottomcover

TOOLS AND MATERIALS REQUIRED

(Cont.)

■Hardwarepackagewith

 –9StainlessSteelTorx15

#8self-tappingscrews

 –9Phillips#2panheadwood#10screws

 –3StainlessSteel#2trusshead#10screws(for

alternate installation method)

Hardware

Package

Top Cover

with Shelf

Bottom Cover

Bottom Wall Support

Top Wall

Support

INSTALL THE WALL SUPPORT PANELS

WARNING The wall support panels must be

securely fastened to the wall. Failure to do so could

result in damage or personal injury.

IMPORTANT: This backsplash is designed to cover

the wall between the bottom of the hood and the top of

the range. The vent hood should be installed over the

rangetop or range before installing this backsplash.

■InstallandleveltheRange/Rangetopaccordingto

the product installation instructions.

■Removebacksplashpackagingandprotectivefilm.

■Locatewallstudsoneachside.Wherestudsarenot

available,plantousewallanchors(notprovided).

■Usealeveltopencil2horizontallinesonthewall,

one1/8”belowtheventhoodandtheother1/8”

abovetheRange/Rangetop.This1/8”spaceallows

the cover panels to overlap the wall supports.

■Securethetopwallsupportpaneltothewallwith4

wood screws, through the outermost studs.

■Use4woodscrewstosecurethebottomwallsupport

panel. The center slot should be positioned at the top.

The gap between the top and bottom support panels

will be covered by the top cover with shelf.

1/8”

Secure the

top panel

to the wall

with 4 wood

screws

1/8”

Secure the

bottom panel

to the wall

with 4 wood

screws

Wood

Screws

Center

Arrow

Wood

Screws

31-10692-101-18GEA

Termékspecifikációk