Használati útmutató Harley Davidson J03893 (2005)
Harley Davidson
Motor
J03893 (2005)
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Harley Davidson J03893 (2005) (2 oldal) a Motor kategóriában. Ezt az útmutatót 20 ember találta hasznosnak és 10.5 felhasználó értékelte átlagosan 4.5 csillagra
Oldal 1/2
-J03893 REV. 2005-08-10
FLHTCUSE HEATED SEAT KIT
GENERAL
Kit Number
51718-06
Models
This kit fits 1997 and later FLHT/I (Electra Glide
® Standard),
FLHTC/I (Electra Glide Classic) and FLHTCUI (Ultra Classic®
Electra Glide), and 1998 and later FLTR/I (Road Glide®)
models.
Additional Parts Required
If another accessory is already using the accessory circuit
connector [4] (under the seat, see Figure 1), the Heated Seat
Kit will require a Switched Circuit Adapter Harness (Part No.
70264-94A), available separately from a Harley-Davidson
dealer.
Electrical Overload
It is possible to overload your motorcycle's charging
system by adding too many electrical accessories. If your
combined electrical accessories operating at any one time
consume more electrical current than your vehicle's
charging system can produce, the electrical consumption
can discharge the battery and cause vehicle electrical
system damage. See a Harley-Davidson dealer for advice
about the amount of current consumed by additional
electrical accessories, or for necessary wiring changes.
(00211b)
When installing any electrical accessory, be certain not
to exceed the maximum amperage rating of the fuse or
circuit breaker protecting the affected circuit being modi-
fied. Exceeding the maximum amperage can lead to elec-
trical failures, which could result in death or serious injury.
(00310a)
The Heated Seat requires up to additional current4.2 Amps
from the electrical system.
Kit Contents
Table 1. Kit Contents
Part NumberDescription (Quantity)
Not Sold SeparatelyHeated seat
51479-06Grab strap
INSTALLATION
1. For 2006 and later FLHT/I/C/CI/CUI, and ALL FLTR
models:
a. Follow the instructions in the Owner's Manual to
remove the left-side and right-side saddlebags
b. Remove the bolts and flat washers to remove the
passenger grab strap and saddlebag front mounting
brackets from the chrome frame tube covers.
c. Remove the passenger grab strap.
2. ALL models: Follow the instructions in the Owner's
Manual to remove the seat.
To prevent accidental vehicle start-up, which could cause
death or serious injury, disconnect negative (-) battery
cable before proceeding. (00048a)
3. Follow the instructions in the Owner's Manual to remove
the negative (-) battery cable from the battery.
4. See Figure 1. Identify and remove the plug from the
accessory circuit connector [4] in front of the battery.
is01034
Figure 1. Accessory Circuit Connector [4] (2004 and Later
Shown)
5. Locate the heated seat connector on the underside of the
heated seat.
-J03893 1 of 2
Termékspecifikációk
| Márka: | Harley Davidson |
| Kategória: | Motor |
| Modell: | J03893 (2005) |
Szüksége van segítségre?
Ha segítségre van szüksége Harley Davidson J03893 (2005), tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók Motor Harley Davidson
29 Szeptember 2024
22 Szeptember 2024
17 Szeptember 2024
27 Augusztus 2024
20 Augusztus 2024
4 Augusztus 2024
3 Augusztus 2024
2 Augusztus 2024
31 Július 2024
30 Július 2024
Útmutatók Motor
- Motor Kawasaki
- Motor Zero
- Motor KTM
- Motor Reebok
- Motor GasGas
- Motor MV Agusta
- Motor BMW
- Motor Husqvarna
- Motor Mitsubishi
- Motor Mahindra
- Motor Royal Enfield
- Motor Danfoss
- Motor Kettler
- Motor Juki
- Motor Suzuki
Legújabb útmutatók Motor
16 Január 2025
12 Január 2025
11 Január 2025
9 Január 2025
9 Január 2025
4 Január 2025
4 Január 2025
3 Január 2025
1 Január 2025
1 Január 2025