Használati útmutató JL Audio MVi-DRCADAPT
JL Audio
távirányító
MVi-DRCADAPT
Olvassa el alább 📖 a magyar nyelvű használati útmutatót JL Audio MVi-DRCADAPT (4 oldal) a távirányító kategóriában. Ezt az útmutatót 8 ember találta hasznosnak és 4.5 felhasználó értékelte átlagosan 4.7 csillagra
Oldal 1/4

Rotary DRC Adaptor for MVi Amplifiers
(Use with rotary-style Digital Remote Controllers only.)
MVi-DRCADAPT

Product Description:
The MVi-DRCADAPT permits the direct connection of a JL Audio rotary-style Digital
Remote Controller (DRC) to a MVi amplifier via its JLid-COMM Port.
Notes: This product is not compatible with mono MV amplifiers or the MVi-HUB.
This product is not needed for connection of M-DRC-50 push-button controller.
What is Included:
(1) MVi-DRCADAPT
(1) Mounting Clip
(2) Mounting Screws
Placement Considerations:
The MVi-DRCADAPT should be installed near the connected MVi amplifier,
where its JLid status LED can be viewed.
Installation:
1. Plug the cable end of the MVi-DRCADAPT into the JLid-COMM port of the MVi amplifier.
2. Install a compatible DRC controller (sold separately) per its instructions and connect its
cable end to the RJ45 jack of the MVi-DRCADAPT.
Mounting Clip Installation:
A mounting clip is included to secure the MVi-DRCADAPT module. Use the supplied screws
to fasten the mounting clip to a flat surface. Once the mounting clip is installed, attach the
MVi-DRCADAPT module by pressing one side of its notched center section against the
inside of one of the arms of the mounting clip. Continue pressing inward until both arms of
the mounting clip snap around the notched center section of the MVi-DRCADAPT module.
Ensure that the JLid Status LED is facing outward and visible. To remove, grasp the module’s
body and pull while rotating away from the mounting clip.
JLid Status LED:
The MVi-DRCADAPT module is equipped with a multi-color status LED.
Refer to the table below for detailed info:
MVi-DRCADAPT LED Color Status
Green JLid™ detection in progress
Blue Successful connection of a compatible DRC
Yellow Unrecognized JLid ™ device
(retry attempts result in ashing Yellow)
Yellow-Green (alternating) Faulty JLid™ device
None (JLid-COMM Port LED of the
connected MVi amplier ashes Red)
Short circuit condition of JLid ™ connection
(MVi-DRCADAPT turns OFF)

To DRC
MVi-DRCADAPT
Connects to the JLid™ COMM Port on MVi ampliers
Note: Components pictured may not be to scale.
DRC sold separately.
Termékspecifikációk
Márka: | JL Audio |
Kategória: | távirányító |
Modell: | MVi-DRCADAPT |
Szüksége van segítségre?
Ha segítségre van szüksége JL Audio MVi-DRCADAPT, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók távirányító JL Audio
31 Augusztus 2024
29 Augusztus 2024
27 Július 2024
25 Július 2024
24 Július 2024
19 Július 2024
17 Július 2024
16 Július 2024
12 Július 2024
12 Július 2024
Útmutatók távirányító
- távirányító Revox
- távirányító Continental Edison
- távirányító ProMaster
- távirányító Bose
- távirányító Tado
- távirányító Aputure
- távirányító Magnus
- távirányító Electia
- távirányító Rockford Fosgate
- távirányító AMX
- távirányító ETiger
- távirányító KPN
- távirányító Xavax
- távirányító Edision
- távirányító Ruwido
Legújabb útmutatók távirányító
9 Április 2025
3 Április 2025
2 Április 2025
1 Április 2025
31 Március 2025
29 Március 2025
29 Március 2025
27 Március 2025
27 Március 2025
27 Március 2025