Használati útmutató Joovy Peg Perego Car Seat Adapter

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Joovy Peg Perego Car Seat Adapter (2 oldal) a Baba termékek kategóriában. Ezt az útmutatót 27 ember találta hasznosnak.

/ 2 PDF

!WARNING

This infant car seat adapter is for use ONLY on the Joovy Zoom Joggers. DO NOT use on other stroller models.

This infant car seat adapter is for use ONLY with the Peg Perego® infant car seat models identied below. DO NOT use other infant car seat

models.

ALWAYS install the infant car seat so that the child is facing toward the rear (handlebar) of the stroller.

ALWAYS position the infant car seat so that it securely snaps into place inside the infant car seat adapter frame.

!WARNING

Before each use, check to make sure all four clamps are secure and all Velcro® straps are fully attached.

Installing/Using the Infant Car Seat Adapter

• UnsnapthevesnapslocatedonBOTHsidesoftheseat.See Figure 1.

• Foldthefabricinsideandunderthestrollerframetubessothatthetubesareclearlyexposedonbothsidesofthestroller.See Figure 2.

• Positionthecanopysoitisopenedhalfway.Reclinetheseattoitsmaximumreclineposition.See Figure 3.

• RemovetheVelcro®strapsfromeachclamp,thenopenallfourclampsontheadapter.

• Placethecarseatadapteronthestrollerframetubessothatthecanopyhingebracketsarebetweentheadapterclamps.See Figure 4.

DO NOT allow any of the seat fabric to be captured by the clamp.

• Closeallfourclampsaroundthestrollerframetubes.See Figure 5. Makesurethatallfourclampsarefullyclosedandnoseatfabricis

capturedbytheclamps.

• InserttheloopendofoneVelcro®strapbetweenoneadapterclampandtheseatfabric.Attachthelooparoundthetabontheclamp.

See Figure 6.

• WraptheVelcro®straptightlyaroundtheclamp.See Figure 7.

• EnsurethatthemiddleloopoftheVelcro®straptsovertheclamptab. See Figure 8.

• ContinuewrappingtightlyuntiltheentirelengthoftheVelcro®strapissecuredtogether.MakesuretheedgesoftheVelcro®strapare

alignedformaximumstrength.See Figure 9.

• RepeatfortheotherthreeclampsandVelcro®straps.

• Closethecanopycompletely.

NOTE: Tomaximizespaceforyourbaby,attachthetwosetsofsnapsfoundontheundersideofthecanopy.See Figure 10.

• PlacethePegPerego®infantcarseat(sothecarseatfacesthehandlebar)intotheadapteruntilthecarseatsnapsintoplace.Pullupon

thecarseattoensureitissecure.See Figure 11.

• Toremovetheinfantcarseat,pullthereleaselever(sameleverusedtoreleasethecarseatfromitsbase)andliftup.

NOTE: strollerfoldswithcarseatadapterinstalled.

Removing the Infant Car Seat Adapter

• Toremovethecarseatadapter,rstpositionthecanopysothatitisopenedhalfway.

• RemoveallfourVelcro®strapsfromtheclamps.

• Openallfourclampsandremovetheadapterfromthestroller.

• ReattachthefourVelcro®strapstotheclampsontheadapterandstoretheadapterforfutureuse.

• WraptheseatfabricoverthestrollerframetubesandreattachthevesnapslocatedonBOTHsidesofthestroller.

Zoom

Peg Perego® Car Seat Adapter

00951

PEG PEREGO® CAR SEAT ADAPTER COMPATABILITY

Peg Perego® Primo Viaggio

Termékspecifikációk