Használati útmutató Kramer 676T

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Kramer 676T (4 oldal) a AV hosszabbító kategóriában. Ezt az útmutatót 15 ember találta hasznosnak és 6 felhasználó értékelte átlagosan 4.8 csillagra

676T, 676R Quick Start

P/N:

2900-301397QS

Rev:

4

Scan for full manual

676T / 676R Quick Start Guide

This guide helps you install and use your 676T/ 676Rfor the rst time.

Go to www.kramerav.com/downloads/676Tor www.kramerav.com/downloads/676R to download the latest

user manual and check if rmware upgrades are available.

Step 1: Check what’s in the b ox

676THDMI Optical Transmitter or

676RHDMI Optical Receiver

1 Bracket set

4 Rubber feet

1 Power cord and adapter

1 Quick start guide

1 OSP-MM1 Fiber Optic SFP+ Transceiver

Step 2: Get to know your 676T and 676R

676T can be connected to a single 676R device or to multiple devices via optical splitters. When multiple devices are connected, a

receiver device is dened as primary when its Tx (SFP+ OUT) optical ber is connected directly to the 676T Rx optical fiber (SFP+ IN).

676T

#

Feature

Function

1

IN LED

Lights green when a connected source device (with an active HDMI signal) is detected. ™

Flashes 4 times green when resetting the device.

O when active signal is detected on the connected HDMI source device. no

2

OUT LED

Lights green when an HDMI acceptor device (with an active HDMI signal) detected. is

O when no active signal is detected on the connected acceptor.

3

LINK LEDs

Tx

Lights green when OUT IN SFP+ is connected, and an active Tx optical link is detected.

Lights red when OUT IN SFP+ is connected, and a fault is detected on the single/primary

676R receiving optical link.

O when the OUT IN SFP+ is disconnected.

Rx

Lights green when OUT IN SFP+ is connected, and an active optical link is detected. Rx

Lights red when OUT IN SFP+ is connected, and a fault is detected on the incoming optical

link.

O when OUT IN SFP+ is disconnected.

4

ONLED

Lights green when the device receives power.

5

HDMI™ IN Connector

Connect to an HDMI source.

6

RS- (Tx, Tr, G) 3-pin 232

Terminal Block Connector

Connect to a serial controller to communicate serial with all the connected receivers. ly

Receives -232 communication only from a single/primary receiver. RS

7

OUT INSFP+ Connector

Connect the ber optic cable to the plugged- SFP+ optical module connectors. in

(OSP-MM1, included).

8

SETUP 4-way DIP-switch

Sets the device behavior.

9

RESET Recessed Button

Press and hold for 5 seconds or less to reset the device.

Press and hold for over 5 seconds to reset the device to factory default values.

10

SERVICE Micro USB Port

Connect to a PC to perform rmware upgrade (via K-Upload).

11

12V DC Power Connector

12V DC connector for powering the unit.

Termékspecifikációk