Használati útmutató LiftMaster 041C0296

Olvassa el alább 📖 a magyar nyelvű használati útmutatót LiftMaster 041C0296 (4 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 13 ember találta hasznosnak és 6 felhasználó értékelte átlagosan 4.9 csillagra

A

B

B

B

C

E

F

D

G

J

I

H

G

G

G

Transformer Replacement Kit

Model 041C0296

Specifications

Volts . . . . . .. . . . . . .. . . . . .. . . . . .. . . . . .. . . .120 Vac - 60 Hz, Only

Current1.5 AMP ...........................................

Rated Load385 in/ lb./sec. . . . .. . . . . .. . . . . .. . . . . .. . . . . .. . . . . ..

WARNING: This product can expose you to chemicals including

lead, which are known to the State of California to cause cancer or

birth defects or other reproductive harm. For more information go

to www.P65Warnings.ca.gov

To prevent possible SERIOUS INJURY or DEATH:

• Disconnect ALL electric and battery power BEFORE performing ANY

service or maintenance.

To prevent damage to the receiver/logic board, DO NOT touch printed

circuit board of replacement receiver/logic board during installation.

ALWAYS wear protective gloves and eye protection when changing the

battery or working around the battery compartment.

9. Cut the zip tie securing the battery wires (H)

to the chassis.

10. Remove the nut and the transformer . (I)

Discard the transformer.

11.Install the new transformer with the nut.

Verify the wiring harness faces forward, as

shown .(J)

12.Reinstall the cover. Verify that the tabs in

the cover align with the holes in the top of

the chassis. Route the wiring harnesses

and wires through the cover.

13.Reinstall the logic board and connect

the wiring harnesses. Route the antenna

through the channel in the cover.

14.Install the battery and connect the battery

connectors. Replace the battery cover.

8.Remove the four screws

securing the cover to

the chassis .(G)

6.Disconnect all the wiring

harnesses from the logic

board .(E)

7. Remove the four screws

securing the logic board,

remove the logic board

(F), and set aside.

4.Disconnect the wires coming

from the safety reversing sensors,

door control, door lock and cable

tension monitor from the logic

board .(C)

NOTE: If there is a resistor located

on the green wire traps, do not

remove.

5.Remove the logic board cover .(D)

1.Disconnect power.

2. Open the front panel . (A)

3.Remove the battery cover.

Disconnect the battery. Remove

the battery and set aside .(B)

Termékspecifikációk