Használati útmutató NUVO 65/210
Oldalak 2 Engels Megkönnyebbülés
Olvassa el ingyen online a(z) NUVO 65/210 használati útmutatóját, vagy töltse le PDF-ben. Az útmutatót 15 ember találta hasznosnak. Kérdése van a modellről? Tegyen fel kérdést
LED DUAL HEAD SECURITY LIGHT
Models without
motion sensor:
65-210, 65-212, 65-214,
65-216, 65-218, 65-220
Satco Products, Inc.
Brentwood, NY 11717© Copyright 2018 Satco Products, Inc. 12/18
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing xture. Retain for future reference.
Models with
motion sensor:
65-211, -213, 65-215,65
65-217, 65-219, 65-221
SAFETY:This xture must be wired in accordance with the National Electrical Code and applicable local codes and ordinances. Proper grounding is
required to insure personal safety. Carefully observe grounding procedure under installation section.
WARNING: Make certain power is OFF before starting installation or attempting any maintenance. Risk of re/electric shock. If not qualied, consult an
electrician.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened rmly. Apply weatherproof
silicone sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs
and unused conduit entries.
CLEANING & MAINTENANCE
CAUTION: Be sure xture temperature is cool enough to touch. Do not clean or maintain while xture is energized.
1. Clean glass lens with non-abrasive glass cleaning solution.
2. Do not open xture to clean the LED. Do not touch the LED.
INSTALLATION
Mounting hardware included
1. Remove xture components and parts pack Check to ensure all parts are included.
Note: Account for small parts and destroy packing material, as these may be hazardous to children.
2.Turn OFF Power at circuit breaker box. CAUTION: Do not rely on wall switch alone to turn off power.
Note: Fixture is intended for Eave or Wall mount above 4 ft. (1,2m) only. Do not mount on ground!
3. Use screw to x the mounting plate and foam in the wall mounting box of the order shown in the drawing.
4. Connect the lamp wiring as drawing. See “wiring”.
5. Fix the lamp on the mounting plate with a screw and cover the gap between the base and the wall with a silicone plug and seal with glue.
WIRING
Ground xture. Use wire nut to connect the (copper) house supply ground wire and the (green) xture ground wire.
Note: If house wiring does not include a ground wire, consult your local electrical code for approved grounding
methods. For proper connection, place wire nut over wires and twist clockwise until tight.
1. Connect supply wires. Use wire nut to connect the black xture wire to the black power supply wire and the
white xture wire to the white (neutral) supply wire.
Note: Lamp heads must be positioned above motion sensor head and controls on motion sensor must face
the ground.
2. Aim lamp heads and install optional visors. Loosen adjustment knobs and aim lamp heads.
CAUTION: Risk of Shock: Aim lamp heads at least 20º down below horizontal in order to prevent water from accumulating inside lens.
After lamp heads are positioned as desired, align the optional visor over the front of the lamp head and secure by tightening set screw on visor.
3. Turn on electricity at fuse or circuit breaker box and verify success of installation.
4. Apply silicone caulking (not included) around the perimeter of the xture where it contacts the mounting surface for moisture seal. After installing your
motion activated light you are ready to set/aim the motion sensor. Make sure the wall switch is in ON position.
TROUBLESHOOTING
1.Check your power source.
2.Check electrical connections.
3.Check that the photo cell or motion sensor is working properly (if so equipped).
Termékspecifikációk
| Márka: | NUVO |
| Kategória: | Megkönnyebbülés |
| Modell: | 65/210 |
Szüksége van segítségre?
Ha segítségre van szüksége NUVO 65/210, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók Megkönnyebbülés NUVO
NUVO Warren 60/8037 Útmutató NUVO Flynn 60/7678 Útmutató NUVO Cordello 60/7886 Útmutató NUVO Ballerina 60/3162 Útmutató NUVO Everton 60/7877 Útmutató NUVO Halter 60/7692 Útmutató NUVO 65/220 Útmutató NUVO Terrace 60/7747 Útmutató
Összes NUVO Megkönnyebbülés használati útmutató
Népszerű termékek – Megkönnyebbülés
Útmutatók Megkönnyebbülés
Legújabb útmutatók Megkönnyebbülés
Yongnuo YNRAY260 Útmutató Rollei LUX Compact RGB Útmutató Rollei LUMIS Key Light Pro Útmutató Rollei LUMIS Mini RGB Útmutató Rollei LUX 100 Bi-Color Útmutató Bresser BR-150RGB Útmutató Godox Litemons LP1200R Útmutató NEO Tools 99-113 Útmutató Moen Belfield YB6461BN Útmutató Kuzco Motif PD75027 Útmutató