Használati útmutató PAC C2R-AUDI

Olvassa el alább 📖 a magyar nyelvű használati útmutatót PAC C2R-AUDI (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 23 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 4.9 csillagra

Radio Replacement Interface with Nav Outputs

for select Audi CANbus Vehicles

With or Without Premium Audio Systems

C2R-AUDI

C

Page 1

© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.

PAC-audio.com

Rev: V3

Date: 060118

Introduction and Features

Important Notes

Wiring Connection Chart

The C2R-AUDI interface allows the replacement of a factory radio in select Audi vehicles with CANbus radios. The C2R-

AUDI also provides a secondary output for adding an optional PAC Steering Wheel Control (SWC) retention interface

(SWI-RC, SWI-CP2, SWI-X). The C2R-AUDI also provides data bus driven outputs such as retained accessory power

(RAP), vehicle speed sensor (VSS), illumination, reverse trigger and parking brake.

1. A PAC steering wheel interface must be used in conjunction for SWC retention.

2. Only one of the two provided radio harnesses will be used. Remove the factory installed radio to determine the correct harness

for your particular vehicle.

3. Vehicles without a factory amplier:Connect the aftermarket radio’s front and rear speaker wires to the 22-pin plug (dock-

n-lock connector) or 16-pin plug (ISO Connector).

4. Vehicles with a factory amplier: To determine whether the amplier needs RCA or speaker level input, check the OEM side

of the 22-pin or 16-pin connector (depending on which connector your vehicle has behind the radio) to see if the speaker wires

are populated. If so hook the front speaker outputs to the main connector and the rear RCA outputs to the 22-pin connector

(dock-n-lock connector) or 16 / 20-pin connector (ISO Connector). If there are no factory speaker wires located in the OEM

main connector then you will need to hook all 4 of the RCAs from the C2R-AUDI harness to the aftermarket radio’s RCA

outputs. The blue RCA has no function at this time (dock-n-lock connector only).

5. The Red accessory wire supplies +12v, 1 Amp max when key is in the accessory or ignition position (see g. 1: If more current

is needed).

Red / WhiteParking Brake Output (-)

Purple / WhiteVehicle Speed Output

Blue / WhiteAmp Turn On Input

RedAccessory Output

Orange / WhiteIllumination Output (+)

GreenReverse Output (+)

Interface Connector

YellowBattery +12v

BlackGround

WhiteFront Left + input

White / BlackFront Left - input

GrayFront Right + input

Gray / BlackFront Right - input

GreenRear Left + input

Green / BlackRear Left - input

PurpleRear Right + input

Purple / BlackRear Right - input

Vehicle Connector

Fig. 1

(using a SPDT relay)

8586

30

87

87a

Ground

High Current 12v

(Fused)

12v Acc.

From

Interface

New High

Current Output

Diode 1N4005

or equivelant

Termékspecifikációk