Használati útmutató Shadow SH950

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Shadow SH950 (1 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 19 ember találta hasznosnak és 5 felhasználó értékelte átlagosan 5.0 csillagra

Kupferfolie

Sensor

Fax: (561) 743 0460

eMail: jjmelch@shadow-pickups.com

Shadow Elektroakustik

Peter-Haendel Straße 2

91334 Hemhofen · Germany

Shadow Electronics of America Inc.

17791 Alexander Run

Jupiter, FL 33478 U.S.A.

Fax: +49 - 91 95 - 92 99 30

eMail:info@shadow-electronics.com

Installation Instruction for Shadow SH 950

Double Side Upright Bass Pickup

Fig. 1Fig. 1

Fig. 2Fig. 2

Content:Content:

2 Upright Bass Transducer with 6.5 mm (1/4”)

output socket and mounting adhesive,

Copper Foil Tape,

Cable Holder

2 Upright Bass Transducer with 6.5 mm (1/4”)

output socket and mounting adhesive,

Copper Foil Tape,

Cable Holder

Note:

Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend

an amplifier with low impedance input.

Note:

Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend

an amplifier with low impedance input.

3.Install the sensors into the bridge slots.

4.Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

5.Connect to appropriate amplifier with instrument cable.

3.Install the sensors into the bridge slots.

4.Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

5.Connect to appropriate amplifier with instrument cable.

1.Test fit sensors into the slot between the wing and foot.

Pickup should fit tightly for best output (see fig 1).

1.Test fit sensors into the slot between the wing and foot.

Pickup should fit tightly for best output (see fig 1).

2.If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.2.If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.

Termékspecifikációk