Használati útmutató Synco WAir-G1-A2

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Synco WAir-G1-A2 (2 oldal) a mikrofon kategóriában. Ezt az útmutatót 16 ember találta hasznosnak.

Thank you for choosing SYNCO product.

Please read this manual carefully before use and follow all instructions mentioned

herein.

Microphone G1(A2) User Manual

Caring For Your SYNCO Product

Please keep the product in a dry, clean, dust-free environment.

Keep corrosive chemicals, liquids and heat source away from the product to

prevent mechanics damage.

Use only a soft and dry cloth for cleaning the product.

Malfunction may be caused by dropping, impact of external force.

Do not attempt to disassemble the product. Doing so voids warranty.

Please have the product checked or repaired by authorized technicians if any

malfunctions happened.

Failure to follow all the instructions may result in mechanics damage.

Warranty does not apply to human errors.

Package List

RX Receiver x1TX Transmitter x2Carrying Bag x1

3-in-1 Charging Cable x1

External Lav Mic (With Wind Mu󽗈) x2

3.5mm TRRS Phone Cable x1

3.5mm TRS Camera Cable x1

Product Instruction

TX Transmitter

RX Receiver

① External Mic Input

② USB-C Port

③ Power

④ Reset(Help with Eject Pin)

⑤ Low Cut

① USB-C Port

② Power(Mono/Stereo Switch)

③ Reset(Help with Eject Pin)

④ Channel A Gain Control

⑤ Channel B Gain Control

⑥ Pairing

⑦ Built-in Mic

⑧ Pocket Clip

⑨ Pairing Indicator

⑩ Power Indicator

⑥ 3.5mm Audio Output

⑦ 3.5mm Monitoring Jack

⑧ Pocket Clip

⑨ Pairing Indicator

⑩ Power Indicator

1.Power Button

Long press the power button for 2 seconds to turn on/o󽗈 the system.

Short press the power button on the RX for Mono/Stereo switch.

2.Pairing

The system will pair automatically after power on. If you need manual

pairing, long press the channel A gain control and channel B gain control

on the RX, and the pairing button on the TX, the system will start to pair.

3.Connection

The receiver outputs audio signals to recording devices with a 3.5mm

TRRS Phone Cable or a 3.5mm TRS Camera Cable. Please use the

corresponding cable based on your device.

4.Installation

Attach the transmitter or the external mic to the speaker’s clothing. Install

the receiver to the camera’s hot shoe via the pocket clip.

(When using the external mic, please insert it into the mic input Note:

properly.)

Operations

Indicator

Slow Flashes

Fast Flashes

Keeps On

Fast 󽗊ashes twice, is

o󽗈 and repeats

Power Indicator (Green)

Power is lower than 10%.

/

It stays green when charging

and is o󽗈 after fully charged.

/

Pairing Indicator (Blue)

Power on

System pairing

System paired

Low cut function is on.

5.Gain Control

The initial value of the gain is the microphone’s original volume. Each

press of the gain control button increases the gain by one level, fourth

level at most. When the gain is at max level, press once and return to

Mic Windshield x1

Eject Pin x1

Termékspecifikációk