Használati útmutató Thermaltake Dr. Power III

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Thermaltake Dr. Power III (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 25 ember találta hasznosnak és 13 felhasználó értékelte átlagosan 4.3 csillagra

Dr.Power III

User Manual

24pin connector

Check button

CPU 4pin or 8pin connector

Peripheral connector

SATA connector

PCI-E 6pin or 8pin connector

12+4pin connector

Connector Introduction

Operation Instructions

Manual Mode

1. Plug the PSU connectors into Dr.Power III.

2Switch the PSU I/O switch to the “-” position. The screen will then display the TT logo animation..

3The screen will display the icons of the connectors that have been plugged into Dr.Power III..

4Press the CHECK button to start the manual testing mode. The screen will display the 24P icon, the output voltage of .

each group, and PG.

5Press the CHECK button again. The system will proceed with the next test point CPU. The screen will display the CPU icon .

and the corresponding voltage output.

6Press the CHECK button again. The system will proceed with the next test point PCI-E. The screen will display the PCI-E icon .

and the corresponding voltage output. If the PCI-E 12+4pin is connected, the screen will display the SENSE0/SENSE1

sideband signals of the PCI-E 12+4pin connector (150W/300W/450W/600W).

7Press the CHECK button again. The system will proceed with the next test point MOX. The screen will display the MOX icon .

and the corresponding voltage output.

8Press the CHECK button again. The system will proceed with the next test point SATA. The screen will display the SATA icon .

and the corresponding voltage output.

9Press the CHECK button again to return to step 3..

10If no fault occurs during the test, the LCD backlight will remain white. Once any fault occurs, the LCD backlight will turn red .

and make a “beep” sound.

Connect all of the

connectors and

turn on the PSU

Press buttonPress button

Press button

Press button

Press button

Press button

Note: 12+4P will only be displayed when

PCI-E 12+4pin is connected.

SATA

SATA

Termékspecifikációk