Használati útmutató Vemer CO Sensor

Oldalak 1 Engels nincs kategorizálva

Olvassa el ingyen online a(z) Vemer CO Sensor használati útmutatóját, vagy töltse le PDF-ben. Az útmutatót 28 ember találta hasznosnak. Kérdése van a modellről? Tegyen fel kérdést

PDF letöltése (0.3 MB) Műszaki adatok

V3IS00462-010

CH4 SensorCO SensorLPG Sensor, and areprobesforthedetectionof

methanegas,carbonmonoxideandLPGtobeconnectedtoSRG and SRG.4

controlunitstocreatesystemsfordetectinggasinareassuchasboilerrooms,

warehouses,etc.

It is wall-mounted in a vertical position using screws and plastic plugs.

SAFETY WARNINGS

During installation and operation of the instrument, comply with the

following instructions:

1) The device must be installed by a competent person

2) Before removing the cover, make sure that power is NOT provided to

the device

3) Before accessing the terminals, make sure that the electrical leads are

not live

4) Install the detector in the correct position (see “Installation”)

5) Do not power on the device if any part of it is damaged

Code Model Description

VE205100CH4SENSOR Methanedetectionsensor

VE206900 LPG SENSOR LPG sensor

VE207700 CO SENSORCarbonmonoxidesensor

TECHNICAL CHARACTERISTICS

• Powersupply:fromthecontrolunitSRGorSRG.4

 −Currentinput(at6.5V):40mA

 −Connection:terminalsof2.5mm2C(common),S(signal),A(powersupply)

• Modelsandcalibration:

 −Methanegas:CH4Sensor,(default)10%LIEofmethane

 −LPG:LPGSensor,(default)12%LIEofisobutene

 −Carbonmonoxide:COSensor,(default)200ppmofcarbonmonoxide

• Max.lengthofconnection:50m

• Container:inself-extinguishingplasticmaterial

• Fastenedtowallusingscrewsandplasticplugs

• Protection:IP30

• Operatingtemperature:0÷+50°C

•Humidity: 90%R.H.withoutcondensation≤

INSTALLATION

 LPG,COandCH4Sensorsaredesignedtobewall-mounted(vertically),using

screwsandplasticplugs.Toproceedwithinstallation,openthecontainerby

unscrewingthescrewlocatedonthelowerside.Makesurenottodamagethe

sensorandnottotouchthecalibrationdevices.

POSITIONING

 Thecorrectinstallationoftheprobeisessentialtoproperoperationofthe

system.Therefore,itmustbeinstalled:

• Inareaswithcirculationofnaturalair;

• Inareasthatarenotsubjecttodustordirtthatmayrenderthesensor

inoperative;

• Nearjetsofwater,intakegrilles,openings,etc.

• Atanadequatedistancefromusersofgassoastopreventthesystemfrom

interveningimproperlyduetofunctionalleakage.

 Also,positioningdependsonthetypeofgastobedetected,specically:

• CH4 Sensor: Methane gas – at top, about 20-30 cm from the ceiling

• LPG Sensor: LPG – at bottom, about 20-30 cm from the ﬂoor

• CO Sensor: carbon monoxide – about 1.5 m from the ﬂoor

 Fornewsystems,theprobemustbeinstalledaslateaspossible,sothattypical

constructionsiteactivitiesdonotdamagethedetector.

CONNECTIONS

 Normalelectricalcablescanbeusedforconnections.Inanycase,when

installationisinplacesthatarestronglyexposedtoelectromagnetic

disturbances,itisadvisabletouseshieldedcables.Thedetectionsystemmust

alwaysbeinoperation.Therefore,theelectricalpowersupplyofthedetector

mustnotincludeswitchesorotherdevicesthatmayaccidentallyshutitoff.The

averagelifespanoftheprobesis5yearsfromthedateofinstallation.Therefore,

attheendofthattimetheywillneedtobereplaced.

Note. Make sure you check operation at least once a year, and in any

case whenever there is an extended period of disuse or in the event of

replacement. Any tampering may compromise correct operation of the

system.

REFERENCE STANDARDS

CompliancewithCommunityDirectives:

2006/95/EC (lowvoltage)

89/336/EECmod.from andfrom92/31/EEC 93/68/EEC(E.M.C.)

isdeclaredwithreferencetothefollowingstandards:

EN 61779-4, EN 50270

User Manual

SENSORS FOR SRG/SRG.4 CONTROL UNITS

Read all the instructions carefully

Dimensions

Connection diagrams

119,0

75,3

36,0

CH4 SENSOR

C SA

SRG/SRG.4

Mod. CH4 SENSOR

Mod. LPG SENSOR

Mod. CO SENSOR

Értékelje ezt az útmutatót

Termékspecifikációk

Márka:	Vemer
Kategória:	nincs kategorizálva
Modell:	CO Sensor

Szüksége van segítségre?

Ha segítségre van szüksége Vemer CO Sensor, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek

Útmutatók nincs kategorizálva Vemer

Vemer Nana Útmutató Vemer EVF-R Útmutató Vemer HT JK-1DA Útmutató Vemer Trillo Útmutató Vemer SOLAR-3 Útmutató Vemer Sequencer 3 Útmutató Vemer FHT-2P3D Útmutató Vemer ADR-D Útmutató

Népszerű termékek – nincs kategorizálva

Vemer VE LAN Útmutató Vemer Athena.Temp Útmutató Vemer PC1R Útmutató